Re: Networkconfiguration with KVM

[Dan Johansson <kvm@dmj.nu>]

On Monday 05 April 2010 22.04:17 Held Bernhard wrote:
> Hi Dan!
> 
> > This should be done over the host-eth3 interface and I have set up the
> > br-eth3 and qtap3 the same way as with the eth1/br-eth1/qtap1 with one
> > difference - the br-eth3 interface is setup without an IP.
> > When doing traffic from the VM to the network I can see traffic on the
> > qtap3 and br-eth3 interface but none on the eth3.
> >
> > Must I specify an IP for the br-eth3 interface?
> 
> No, an IP is not required. Just activate br-eth3 and don't forget to add
> a route:
> 
> ifconfig br-eth3 up 0.0.0.0
> route add 192.168.3.0 netmask 255.255.255.0 eth3
Hi All,

A big THANKS to all of you - I finally got it to work. I must have messed up 
something on the Host when I was trying. After a reboot of the Host and then 
creating the br-???, qtap? and so on again it started working.

Once again - THANKS!
-- 
Dan Johansson, <http://www.dmj.nu>
***************************************************
This message is printed on 100% recycled electrons!
***************************************************