public inbox for kvm@vger.kernel.org
 help / color / mirror / Atom feed
From: Kashyap Chamarthy <kchamart@redhat.com>
To: Paolo Bonzini <pbonzini@redhat.com>
Cc: Jan Kiszka <jan.kiszka@siemens.com>,
	kvm@vger.kernel.org, dgilbert@redhat.com
Subject: Re: [nVMX] With 3.20.0-0.rc0.git5.1 on L0, booting L2 guest results in L1 *rebooting*
Date: Thu, 19 Feb 2015 13:07:19 +0100	[thread overview]
Message-ID: <20150219120719.GJ11686@tesla.redhat.com> (raw)
In-Reply-To: <54E4C0FD.4090906@redhat.com>

On Wed, Feb 18, 2015 at 05:42:37PM +0100, Paolo Bonzini wrote:
> 
> 
> On 17/02/2015 12:24, Kashyap Chamarthy wrote:
> > Afraid, I didn't bisect it, but I just wanted to note that the above
> > specific WARN was introduced in the above commit.
> > 
> > I'm sure this Kernel (on L0) does not exhibit the problem:
> > kernel-3.17.4-301.fc21.x86_64. But, if I had either of these two Kernels
> > on the physical host, then the said problem manifests (L1 reboots):
> > 3.19.0-1.fc22 or kernel-3.20.0-0.rc0.git5.1.fc23
> 
> Nested APICv is not part of 3.19, so it cannot be the culprit.
> 
> Can you try 3.18?

Just did two tests with 3.18:

(1) Kernel 3.18 on L0 and 3.20 on L1

    Result: Booting L2 guest causes L1 to reboot, and the same[*] stack
            trace on L0 (mentioned on this thread previously).

            But, annoyingly enough, when I did test (2) below, and then
            switched back to test (1), I don't notice the said stack
            trace in L0's `dmesg` however many times I boot an L2 guest.

(2) Kernel 3.18 on both L0 and L1

    Result: Booting L2 guest causes L1 to reboot, but *no* stack trace
            on L0



[*] Stack trace from test (1)

. . .
[ 4120.296552] ------------[ cut here ]------------
[ 4120.301190] WARNING: CPU: 6 PID: 1841 at arch/x86/kvm/vmx.c:8962 nested_vmx_vmexit+0x7ee/0x880 [kvm_intel]()
[ 4120.311048] Modules linked in: xt_CHECKSUM iptable_mangle ipt_MASQUERADE nf_nat_masquerade_ipv4 iptable_nat nf_nat_ipv4 nf_nat nf_conntrack_ipv4 nf_defrag_ipv4 xt_conntrack nf_conntrack tun bridge stp llc ip6table_filter ip6_tables cfg80211 rfkill coretemp kvm_intel kvm iTCO_wdt gpio_ich iTCO_vendor_support joydev crc32c_intel lpc_ich ipmi_devintf ipmi_si tpm_tis shpchp i7core_edac dcdbas mfd_core tpm ipmi_msghandler serio_raw edac_core acpi_power_meter wmi acpi_cpufreq mgag200 i2c_algo_bit drm_kms_helper ttm drm megaraid_sas ata_generic bnx2 pata_acpi
[ 4120.361643] CPU: 6 PID: 1841 Comm: qemu-system-x86 Not tainted 3.18.7-200.fc21.x86_64 #1
[ 4120.369757] Hardware name: Dell Inc. PowerEdge R910/0P658H, BIOS 2.8.2 10/25/2012
[ 4120.377269]  0000000000000000 00000000e947d406 ffff88bf21f27c48 ffffffff8175e686
[ 4120.384866]  0000000000000000 0000000000000000 ffff88bf21f27c88 ffffffff810991d1
[ 4120.392469]  ffff88bf21f27c98 ffff887f1f73e000 0000000000000000 0000000000000014
[ 4120.400033] Call Trace:
[ 4120.402533]  [<ffffffff8175e686>] dump_stack+0x46/0x58
[ 4120.407714]  [<ffffffff810991d1>] warn_slowpath_common+0x81/0xa0
[ 4120.413740]  [<ffffffff810992ea>] warn_slowpath_null+0x1a/0x20
[ 4120.419611]  [<ffffffffa1cee0ee>] nested_vmx_vmexit+0x7ee/0x880 [kvm_intel]
[ 4120.426609]  [<ffffffffa1cee5af>] ? vmx_handle_exit+0x1bf/0xaa0 [kvm_intel]
[ 4120.433585]  [<ffffffffa1cee39c>] vmx_queue_exception+0xfc/0x150 [kvm_intel]
[ 4120.440697]  [<ffffffffa0192dfd>] kvm_arch_vcpu_ioctl_run+0xd9d/0x1290 [kvm]
[ 4120.447783]  [<ffffffffa018e528>] ? kvm_arch_vcpu_load+0x58/0x220 [kvm]
[ 4120.454436]  [<ffffffffa017acbc>] kvm_vcpu_ioctl+0x32c/0x5c0 [kvm]
[ 4120.460650]  [<ffffffff817634cd>] ? down_read+0x1d/0x30
[ 4120.465915]  [<ffffffff8122a1c0>] do_vfs_ioctl+0x2d0/0x4b0
[ 4120.471431]  [<ffffffff8122a421>] SyS_ioctl+0x81/0xa0
[ 4120.476477]  [<ffffffff81765429>] system_call_fastpath+0x12/0x17
[ 4120.482533] ---[ end trace 5410644656637166 ]---
[ 4128.015867] kvm [1768]: vcpu0 unhandled rdmsr: 0x1c9
[ 4128.020849] kvm [1768]: vcpu0 unhandled rdmsr: 0x1a6
[ 4128.025848] kvm [1768]: vcpu0 unhandled rdmsr: 0x3f6
. . .

-- 
/kashyap

  reply	other threads:[~2015-02-19 12:07 UTC|newest]

Thread overview: 24+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-02-16 20:40 [nVMX] With 3.20.0-0.rc0.git5.1 on L0, booting L2 guest results in L1 *rebooting* Kashyap Chamarthy
2015-02-17  6:02 ` Jan Kiszka
2015-02-17 11:24   ` Kashyap Chamarthy
2015-02-17 18:00     ` Bandan Das
2015-02-17 18:07       ` Jan Kiszka
2015-02-18 10:20         ` Kashyap Chamarthy
2015-02-18 16:42     ` Paolo Bonzini
2015-02-19 12:07       ` Kashyap Chamarthy [this message]
2015-02-19 15:01         ` Radim Krčmář
2015-02-19 16:02           ` Radim Krčmář
2015-02-19 16:07             ` Radim Krčmář
2015-02-19 21:10             ` Kashyap Chamarthy
2015-02-19 22:28               ` Kashyap Chamarthy
2015-02-20 16:14                 ` Radim Krčmář
2015-02-20 19:45                   ` Kashyap Chamarthy
2015-02-22 15:46                     ` Kashyap Chamarthy
2015-02-23 13:56                       ` Radim Krčmář
2015-02-23 16:14                         ` Kashyap Chamarthy
2015-02-23 17:09                           ` Kashyap Chamarthy
2015-02-23 18:05                             ` Kashyap Chamarthy
2015-02-24 16:30                               ` [PATCH] KVM: nVMX: mask unrestricted_guest if disabled on L0 Radim Krčmář
2015-02-24 16:39                                 ` Jan Kiszka
2015-02-24 18:32                                   ` Bandan Das
2015-02-25 15:50                                 ` Kashyap Chamarthy

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20150219120719.GJ11686@tesla.redhat.com \
    --to=kchamart@redhat.com \
    --cc=dgilbert@redhat.com \
    --cc=jan.kiszka@siemens.com \
    --cc=kvm@vger.kernel.org \
    --cc=pbonzini@redhat.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox