[kvm-unit-tests PATCH 4/9] s390x: topology: Don't use non unique message

[Nina Schoetterl-Glausch <nsg@linux.ibm.com>]

When we test something, i.e. do a report() we want unique messages,
otherwise, from the test output, it will appear as if the same test was
run multiple times, possible with different PASS/FAIL values.

Convert some reports that don't actually test anything topology specific
into asserts.
Refine the report message for others.

Signed-off-by: Nina Schoetterl-Glausch <nsg@linux.ibm.com>
---
 s390x/topology.c | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/s390x/topology.c b/s390x/topology.c
index 49d6dfeb..5374582f 100644
--- a/s390x/topology.c
+++ b/s390x/topology.c
@@ -114,7 +114,7 @@ static void check_polarization_change(void)
 	report_prefix_push("Polarization change");
 
 	/* We expect a clean state through reset */
-	report(diag308_load_reset(1), "load normal reset done");
+	assert(diag308_load_reset(1));
 
 	/*
 	 * Set vertical polarization to verify that RESET sets
@@ -123,7 +123,7 @@ static void check_polarization_change(void)
 	cc = ptf(PTF_REQ_VERTICAL, &rc);
 	report(cc == 0, "Set vertical polarization.");
 
-	report(diag308_load_reset(1), "load normal reset done");
+	assert(diag308_load_reset(1));
 
 	cc = ptf(PTF_CHECK, &rc);
 	report(cc == 0, "Reset should clear topology report");
@@ -137,25 +137,25 @@ static void check_polarization_change(void)
 	report(cc == 0, "Change to vertical");
 
 	cc = ptf(PTF_CHECK, &rc);
-	report(cc == 1, "Should report");
+	report(cc == 1, "Should report change after horizontal -> vertical");
 
 	cc = ptf(PTF_REQ_VERTICAL, &rc);
 	report(cc == 2 && rc == PTF_ERR_ALRDY_POLARIZED, "Double change to vertical");
 
 	cc = ptf(PTF_CHECK, &rc);
-	report(cc == 0, "Should not report");
+	report(cc == 0, "Should not report change after vertical -> vertical");
 
 	cc = ptf(PTF_REQ_HORIZONTAL, &rc);
 	report(cc == 0, "Change to horizontal");
 
 	cc = ptf(PTF_CHECK, &rc);
-	report(cc == 1, "Should Report");
+	report(cc == 1, "Should report change after vertical -> horizontal");
 
 	cc = ptf(PTF_REQ_HORIZONTAL, &rc);
 	report(cc == 2 && rc == PTF_ERR_ALRDY_POLARIZED, "Double change to horizontal");
 
 	cc = ptf(PTF_CHECK, &rc);
-	report(cc == 0, "Should not report");
+	report(cc == 0, "Should not report change after horizontal -> horizontal");
 
 	report_prefix_pop();
 }
-- 
2.41.0