Re: After upgrading from F7 kvm-65-15 to F10 kvm-74-10

[Gerry Reno <greno@verizon.net>]

Gerry Reno wrote:
> Gerry Reno wrote:
>> Hi,
>>  We had setup a number of VM's using KVM-65 running on F7 some time 
>> ago.  We just ocmpleted upgrading a number of hosts to F10 and with 
>> that came KVM-74-10.  We had some problems after that upgrade.  

>> we are having a lot of problems with the dreaded "TCP/IP VNC 
>> connection to hypervisor host has been refused or disconnected".  
>> This has now happened to one of the VM's after it was shutdown and 
>> then we tried to Run it again and we haven't found a way to reconnect 
>> to it.  
This is happening on a VM that was just anaconda upgraded to F9 and is 
on its first reboot.  But that reboot we cannot make happen because the 
VM refuses to run.

>> Also, another VM has this weird problem that when you run it, it 
>> looks like its running because the screen keeps changing size but all 
>> we see is a blank palette on the console page, no screen at all, but 
>> the thing is running.  How do we fix these things?
We kicked everyone off the VM's and rebooted the host and now we have 
access again to this VM. 


>>
> And we have a VM that when you start it says its Connecting to console 
> for guest.  But the console message just stays like that and yet the 
> machine completely boots up and we can log into it remotely in a 
> terminal window.  We just cannot get a console screen.
This also got corrected through a host reboot.


So the only problem I'm very concerned about at the moment is the VM 
that was at the point of first reboot after the successful completion of 
an F9 install.  Any suggestions as to how to get that VM running?


Regards,
Gerry