From mboxrd@z Thu Jan 1 00:00:00 1970 From: Marc Reichman Date: Thu, 22 Apr 2004 13:33:36 +0000 Subject: Re: [LARTC] wondershaper, host *exclusion*? Message-Id: <4087C9B0.7080104@virage.com> List-Id: References: <4087C283.2090504@virage.com> In-Reply-To: <4087C283.2090504@virage.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org I will research in the howto, but I must say a lot of the terminology goes over my head. To summarize, my steps are: 1. create a queue with no bw limitations 2. create a filter for the 192.168.0.0/24 and point it at that queue. Correct? -Marc Simon Oosthoek wrote: > Marc Reichman wrote: > >> Hi, >> >> I really like the wondershaper script, it works very well for me. My >> question is this. Is there a way to get certain remote hosts to be >> excluded from the shaping? I ask because I don't have my box connected >> directly through the net. It sits behind a nat device, and has ports >> forwarded in for services. I'd like to limit the ports and services, but >> only to things going outside of my local network. >> >> Is there a way I can leave most things as-is, and just say "don't affect >> any packets that are involved with 192.168.0.*"? > > > I'm not sure I understand your topology, but I figure you're behind a > NATting adsl/cable modem with a built-in switch? > > You should probably add a separate queue which is not limited in > bandwidth and create a filter for ip range 192.168.0.0/24 to be directed > to that queue. The other traffice should be directed to the other queue > which is standard in wshaper. I don't have specific code-lines, but > you're probably helped more anyway if you find out how to do this from > the howto ;-) > > Cheers > > Simon > > > _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/