Re: [LARTC] Load Balance Outbound AND Inbound Internet Traffic to

[Andy Furniss <andy.furniss@dsl.pipex.com>]

Joe Nuts wrote:
> I've read through the nano documentation, and it says that it wont
> handle scenarios where the main traffic is input. Also, I've read
> through the linuxvirtualserver documentation, and i dont think that
> applies to me either, as that set up intercepts traffic and
> manipulates the final destination IP and port for the traffic.
> What I would like to do is 
> 1) from the ISP standpoint, deliver traffic for a given public IP
> network to a client over multiple (load balanced) links. I have a
> linux router on site that receives traffic for this network, but i
> dont know how to encapsulate / balance the traffic so it gets to the
> client site.
> 
> 2) from the client standpoint, receive traffic for that given public
> IP network, deliver it accordingly to computers, and also, send out
> traffic from the computers on it's network with the correct public IP
> source address.
> it's actually a lot like the
> http://www.linuxvirtualserver.org/VS-IPTunneling.html diagram, but
> instead of the "server" sending / manipulating packets to go to three
> destinations, it's taking a complete (sub)network of 16 or so IP's and
> sending them directly to one computer.
> 
> Any suggestions are greatly appreciated
> Thanks
> -Joe Comeaux


If you have boxes at both ends of the links then you could use multilink 
ppp. Maybe I don't understand the setup properly.

Andy.


_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/