From mboxrd@z Thu Jan 1 00:00:00 1970 From: bert hubert Date: Sat, 01 Dec 2001 00:57:48 +0000 Subject: Re: [LARTC] Does this work: CBQ on PPP over a PTY Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org On Tue, Nov 27, 2001 at 03:01:51PM +0100, Sebastian 'spax' Pape wrote: > hi! > > > What did you set as 'bandwidth'? The bandwith of the ethernet you are > > sending to? The bandwidth of your cable modem? > I am using cbq with the roaring penguin pppoe and cbq is working fine > for outgoing traffic here. I set the speed of my ethernet as bandwidth > and created a root-class with the speed of my adsl as rate. If I look > at the incoming traffic it shows that it only does anything if the > rate of the root class is approx. half of my available bandwidth. It > seems that cbq miscalculates something - but I'm not sure. I sent my > config to the list some time ago and askes for advice - but nothing > seemed wrong. Well, this might very well fit the general brokenness of CBQ idle time determinations. Try HTB (google://htb+devik). I'm now convinced that CBQ is by no means reliable for shaping on all interfaces. Regards, bert -- http://www.PowerDNS.com Versatile DNS Software & Services Trilab The Technology People Netherlabs BV / Rent-a-Nerd.nl - Nerd Available - 'SYN! .. SYN|ACK! .. ACK!' - the mating call of the internet _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/