Re: [LARTC] Invalid Argument

[Stef Coene <stef.coene@docum.org>]

On Wednesday 06 November 2002 16:37, Emmanuel Khamissian wrote:
> Hi,
>
> I use tc to shape my internet traffic with linux Debian on a i386 box.
> (I want to give lowest priority at napster, edonkey, and all parasit
> flow).
> I think that i have a good kernel configuration because i put all QoS
> and networking option in module state.
>
> All ip command run correctly, and tc qdisc and class too.
>
> But !
> 1 - When i make a depmod i have :
>
> depmod: *** Unresolved symbols in
> /lib/modules/2.4.19/kernel/net/sched/cls_fw.o
> depmod: *** Unresolved symbols in
> /lib/modules/2.4.19/kernel/net/sched/cls_route.o
> depmod: *** Unresolved symbols in
> /lib/modules/2.4.19/kernel/net/sched/cls_rsvp.o
> depmod: *** Unresolved symbols in
> /lib/modules/2.4.19/kernel/net/sched/cls_rsvp6.o
> depmod: *** Unresolved symbols in
> /lib/modules/2.4.19/kernel/net/sched/cls_tcindex.o
> depmod: *** Unresolved symbols in
> /lib/modules/2.4.19/kernel/net/sched/cls_u32.o
>
> 2 - When i make a
> tc filter add dev eth1 parent 1:0 protocol ip handle 1 fw classid 1:1
> it says me :
> RTNETLINK answers: Invalid argument
>
> I try a lot of combination and syntax but nothing to do ... i always
> have Invalid Argument as response.
>
> Of course, i have already configured a qdisc and the classes.
>
> Does somebody have any ideas ?
Yes.  You have problems with the modules as you can see in 1 so the commands 
in 2 are failing because the needed module can not be loaded.  Solution : 
recompile the kernel + modules so they match.  Before you compile, do "make 
clean" so all old compiled files are gone.

Stef

-- 

stef.coene@docum.org
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/