* "Found HC with no IRQ" empty /proc/bus/usb
@ 2005-04-01 18:00 Allan Mcintosh
[not found] ` <424D8C48.1090804-sAvY64jVBerkQYj/0HfcvtBPR1lH4CV8@public.gmane.org>
0 siblings, 1 reply; 2+ messages in thread
From: Allan Mcintosh @ 2005-04-01 18:00 UTC (permalink / raw)
To: acpi-devel-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f
Hey,
On my debian Dual 550MHz Pentium III machine, I am unable to get usb
working. I didn't notice anything obvious in the bios that would disable
USB. Any suggestions would be greatly appreciated.
I have tried several kernels, most recently 2.6.10 and 2.6.11.5.
I have also tried booting with variations of
append="noapic acpi=off pci=biosirq"
Upon loading uhci_hcd module I see the following
$ dmesg
<snip>
usbcore: registered new driver usbfs
usbcore: registered new driver hub
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.0:USB HID core driver
USB Universal Host Controller Interface driver v2.2
PCI: Enabling device 0000:00:07.2 (0000 -> 0001)
PCI: No IRQ known for interrupt pin C of device 0000:00:07.2. Probably
buggy MP table.
uhci_hcd 0000:00:07.2: Found HC with no IRQ. Check BIOS/PCI
0000:00:07.2 setup!
$ lspci -vv
<snip>
0000:00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev
01) (prog-if 00 [UHCI])
Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin D routed to IRQ 0
Region 4: I/O ports at ef80 [size=32]
$ lsmod
Module Size Used by
uhci_hcd 34640 0
ehci_hcd 34180 0
usbhid 33184 0
usbcore 123096 3 uhci_hcd,ehci_hcd,usbhid
<snip>
--
Allan McIntosh
Software Designer
Atreus Systems, Inc.
613-233-1741 ext: 217 (Office)
613-233-8204 (Fax)
amcintosh-sAvY64jVBerkQYj/0HfcvtBPR1lH4CV8@public.gmane.org <mailto:amcintosh-sAvY64jVBerkQYj/0HfcvtBPR1lH4CV8@public.gmane.org>
www.atreus-systems.com <http://www.atreus-systems.com/>
-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click
^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: "Found HC with no IRQ" empty /proc/bus/usb
[not found] ` <424D8C48.1090804-sAvY64jVBerkQYj/0HfcvtBPR1lH4CV8@public.gmane.org>
@ 2005-04-03 15:27 ` Sergio Monteiro Basto
0 siblings, 0 replies; 2+ messages in thread
From: Sergio Monteiro Basto @ 2005-04-03 15:27 UTC (permalink / raw)
Cc: acpi-devel
is the age of the Bios is less then 2001 ? probably is , if so, you
should append "acpi=force" to enable ACPI.
On some Bios configurations, you also have to enable ACPI and disable
APM ( on Bios configuration )
On Fri, 2005-04-01 at 13:00 -0500, Allan Mcintosh wrote:
> Hey,
>
> On my debian Dual 550MHz Pentium III machine, I am unable to get usb
> working. I didn't notice anything obvious in the bios that would disable
> USB. Any suggestions would be greatly appreciated.
>
> I have tried several kernels, most recently 2.6.10 and 2.6.11.5.
> I have also tried booting with variations of
>
> append="noapic acpi=off pci=biosirq"
>
>
> Upon loading uhci_hcd module I see the following
>
> $ dmesg
> <snip>
> usbcore: registered new driver usbfs
> usbcore: registered new driver hub
> usbcore: registered new driver hiddev
> usbcore: registered new driver usbhid
> drivers/usb/input/hid-core.c: v2.0:USB HID core driver
> USB Universal Host Controller Interface driver v2.2
> PCI: Enabling device 0000:00:07.2 (0000 -> 0001)
> PCI: No IRQ known for interrupt pin C of device 0000:00:07.2. Probably
> buggy MP table.
> uhci_hcd 0000:00:07.2: Found HC with no IRQ. Check BIOS/PCI
> 0000:00:07.2 setup!
>
>
>
> $ lspci -vv
> <snip>
> 0000:00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev
> 01) (prog-if 00 [UHCI])
> Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Interrupt: pin D routed to IRQ 0
> Region 4: I/O ports at ef80 [size=32]
>
>
> $ lsmod
> Module Size Used by
> uhci_hcd 34640 0
> ehci_hcd 34180 0
> usbhid 33184 0
> usbcore 123096 3 uhci_hcd,ehci_hcd,usbhid
> <snip>
>
>
>
>
>
>
>
>
>
--
Sérgio M.B.
-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2005-04-03 15:27 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2005-04-01 18:00 "Found HC with no IRQ" empty /proc/bus/usb Allan Mcintosh
[not found] ` <424D8C48.1090804-sAvY64jVBerkQYj/0HfcvtBPR1lH4CV8@public.gmane.org>
2005-04-03 15:27 ` Sergio Monteiro Basto
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox