[PATCH 4/5] ACPI: Kill overly verbose "power state" log messages

Len Brown
2009-09-27T08:32:48Z

From: Roland Dreier <rdreier@cisco.com>

I was recently lucky enough to get a 64-CPU system, so my kernel log
ends up with 64 lines like:

ACPI: CPU0 (power states: C1[C1] C2[C3])

This is pretty useless clutter because this info is already available
after boot from both /sys/devices/system/cpu/cpu*/cpuidle/state?/ as
well as /proc/acpi/processor/CPU*/power.

So just delete the code that prints the C-states in processor_idle.c.

Signed-off-by: Roland Dreier <rolandd@cisco.com>
Signed-off-by: Len Brown <len.brown@intel.com>
---
drivers/acpi/processor_idle.c | 7 -------
1 files changed, 0 insertions(+), 7 deletions(-)

diff --git a/drivers/acpi/processor_idle.c b/drivers/acpi/processor_idle.c
index cc61a62..706eacf 100644
--- a/drivers/acpi/processor_idle.c
+++ b/drivers/acpi/processor_idle.c
@@ -1214,13 +1214,6 @@ int __cpuinit acpi_processor_power_init(struct acpi_processor *pr,
acpi_processor_setup_cpuidle(pr);
if (cpuidle_register_device(&pr->power.dev))
return -EIO;
-
- printk(KERN_INFO PREFIX "CPU%d (power states:", pr->id);
- for (i = 1; i <= pr->power.count; i++)
- if (pr->power.states[i].valid)
- printk(" C%d[C%d]", i,
- pr->power.states[i].type);
- printk(")\n");
}
#ifdef CONFIG_ACPI_PROCFS
/* 'power' [R] */
--
1.6.0.6