From mboxrd@z Thu Jan 1 00:00:00 1970 From: "Rafael J. Wysocki" Subject: Re: [PATCH v2 2/4] mfd: lpc_ich: Do not create iTCO watchdog when WDAT table exists Date: Wed, 28 Sep 2016 00:07:49 +0200 Message-ID: <1611175.DW5CysW0GN@vostro.rjw.lan> References: <20160920123054.195021-1-mika.westerberg@linux.intel.com> <20160920123054.195021-3-mika.westerberg@linux.intel.com> <20160927194114.GL21388@dell> Mime-Version: 1.0 Content-Type: text/plain; charset="utf-8" Content-Transfer-Encoding: 7Bit Return-path: Received: from cloudserver094114.home.net.pl ([79.96.170.134]:55541 "HELO cloudserver094114.home.net.pl" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with SMTP id S1752504AbcI0WBZ (ORCPT ); Tue, 27 Sep 2016 18:01:25 -0400 In-Reply-To: <20160927194114.GL21388@dell> Sender: linux-acpi-owner@vger.kernel.org List-Id: linux-acpi@vger.kernel.org To: Lee Jones Cc: Mika Westerberg , Wim Van Sebroeck , Guenter Roeck , Len Brown , Jean Delvare , Wolfram Sang , Peter Tyser , Zha Qipeng , Darren Hart , linux-acpi@vger.kernel.org, linux-kernel@vger.kernel.org On Tuesday, September 27, 2016 08:41:14 PM Lee Jones wrote: > On Tue, 20 Sep 2016, Mika Westerberg wrote: > > > ACPI WDAT table is the preferred way to use hardware watchdog over the > > native iTCO_wdt. Windows only uses this table for its hardware watchdog > > implementation so we should be relatively safe to trust it has been > > validated by OEMs > > > > Prevent iTCO watchdog creation if we detect that there is ACPI WDAT table. > > > > Signed-off-by: Mika Westerberg > > Reviewed-by: Guenter Roeck > > --- > > drivers/mfd/lpc_ich.c | 4 ++++ > > 1 file changed, 4 insertions(+) > > Applied, thanks. Well, I applied this too. And it depends on the [1/4], doesn't it? > > > diff --git a/drivers/mfd/lpc_ich.c b/drivers/mfd/lpc_ich.c > > index bd3aa4578346..c8dee47b45d9 100644 > > --- a/drivers/mfd/lpc_ich.c > > +++ b/drivers/mfd/lpc_ich.c > > @@ -984,6 +984,10 @@ static int lpc_ich_init_wdt(struct pci_dev *dev) > > int ret; > > struct resource *res; > > > > + /* If we have ACPI based watchdog use that instead */ > > + if (acpi_has_watchdog()) > > + return -ENODEV; > > + > > /* Setup power management base register */ > > pci_read_config_dword(dev, priv->abase, &base_addr_cfg); > > base_addr = base_addr_cfg & 0x0000ff80; > > Thanks, Rafael