thinkpad R31 issues

thinkpad R31 issues

[Bernd Schubert]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

with 2.6.5 the S1 state doesn't work anymore on my R31, but until my previous 
2.6.2-rc2 it worked.
To be more specific, it doesn't wake up properly any more, but stops at 
writing:

PCI: Setting latency timer of device 0000:00:1f.6 to 64

There's also a slight improvement, when it goes to S1 the the sleep symbol now 
lights up. However, since S1 it totally useless now, this doesn't improve 
much ;-)

Any ideas what might cause not to wake up from S1 any more?

Also interesting is the boot message:

ACPI: PCI Interrupt Link [PILC] enabled at IRQ 11
 pci_irq-0316 [28] acpi_pci_irq_derive   : Unable to derive IRQ for device 
0000:00:1f.1
ACPI: No IRQ known for interrupt pin A of device 0000:00:1f.1 - using IRQ 255

I think this is there since about 2.6.0 or 2.6.1, but as I said at least until 
2.6.2-rc2 S1  still worked.

There's also the issue that in S1 the display doesn't go off and there are 
several other problems with S3, but IMHO those are minor to a non working S1. 
Interesting is also that S4 is working *again*, whereas it didn't work in 
several previous versions (I only tested regularly until 2.6.2-rc2).

Are you interested in full dmesg and lspci output? Are there any debugging 
methods?

Thanks,
	Bernd

PS: I disabled the preemtive mode in the kernel configuration.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFAcLhLC8BUnAF+ydYRAm5LAKCYi0bY7iDJSUELmP6EsV7G0tiWxQCcDCJB
6TAPlCmLSuOZa04BIJeFUdY=
=kCZZ
-----END PGP SIGNATURE-----


-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id\x1470&alloc_id638&op=click