[patch 03/12] dell_laptop: when the "hardware" switch is disabled, don't actually allow changing the softblock status.

akpm
2009-11-17T22:28:37Z

From: Mario Limonciello <Mario_Limonciello@Dell.com>

The "hardware" switch is tied directly to a BIOS interface that will
connect and disconnect the hardware from the bus.

If you use the software interface to request the BIOS to make these
changes, the HW switch will be in an inconsistent state and LEDs may not
reflect the state of the HW.

Signed-off-by: Mario Limonciello <Mario_Limonciello@Dell.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
---

drivers/platform/x86/dell-laptop.c | 4 ++++
1 file changed, 4 insertions(+)

diff -puN drivers/platform/x86/dell-laptop.c~dell_laptop-when-the-hardware-switch-is-disabled-dont-actually-allow-changing-the-softblock-status drivers/platform/x86/dell-laptop.c
--- a/drivers/platform/x86/dell-laptop.c~dell_laptop-when-the-hardware-switch-is-disabled-dont-actually-allow-changing-the-softblock-status
+++ a/drivers/platform/x86/dell-laptop.c
@@ -181,6 +181,10 @@ static int dell_rfkill_set(void *data, b
unsigned long radio = (unsigned long)data;

memset(&buffer, 0, sizeof(struct calling_interface_buffer));
+ dell_send_request(&buffer, 17, 11);
+ if (!(buffer.output[1] & BIT(16)))
+ return -EINVAL;
+
buffer.input[0] = (1 | (radio<<8) | (disable << 16));
dell_send_request(&buffer, 17, 11);

_