I have the same problem with my Dell Inspiron 5150. Battery status AND temperature reading stopped working when I upgraded from 2.6.0-test11-mm to 2.6.0-mm1. I noticed it because klaptop stopped showing the battery charge status, and gkrellm2 stopped showing the battery and temperature status (stuck at 25C). Actually, the only thing that still works with the battery is wether the AC is plugged in or not. Here is my /proc and dmesg from 2.6.0-mm1. I can reboot and show you the working test11-mm stuff as well, if needed. root-2T+B9ReNDUQ@public.gmane.org maalox # cat /proc/acpi/thermal_zone/THM/temperature temperature: 25 C root-2T+B9ReNDUQ@public.gmane.org maalox # cat /proc/acpi/battery/BAT0/alarm alarm: unsupported root-2T+B9ReNDUQ@public.gmane.org maalox # cat /proc/acpi/battery/BAT0/info present: yes design capacity: 0 mWh last full capacity: 0 mWh battery technology: non-rechargeable design voltage: 0 mV design capacity warning: 0 mWh design capacity low: 0 mWh capacity granularity 1: 0 mWh capacity granularity 2: 0 mWh model number: serial number: battery type: OEM info: root-2T+B9ReNDUQ@public.gmane.org maalox # cat /proc/acpi/battery/BAT0/state present: yes capacity state: ok charging state: unknown present rate: 0 mW remaining capacity: 0 mWh present voltage: 0 mV All the 0 readings have actual numbers with test11-mm, as well as model number, serial number, ... Thanks, Mark From: Brown, Len RE: acpi-20031203-2.6.0.diff brokes the battery status readings with 2.6.0 in DELL Inspiron 8500 2003-12-19 08:11 dmesg from before and after would help, plus the info under /proc/acpi/battery. Thanks, -Len > -----Original Message----- > From: acpi-devel-admin-I+uqrFQUvWk@public.gmane.org > [mailto:acpi-devel-admin-I+uqrFQUvWk@public.gmane.org] On Behalf Of > Pere Castaņer > Sent: Thursday, December 18, 2003 7:00 PM > To: acpi-devel > Subject: [ACPI] acpi-20031203-2.6.0.diff brokes the battery > status readings with 2.6.0 in DELL Inspiron 8500 > > > I've just aplyied last patch into 2.6.0 stable release and it > brokes the battery monitor from acpi in > /proc/acpi/battery/BAT0/status...because of this > gnome-battery applet don't shows any information. > > Do you need more information? > > PS:with acpi included on 2.6.0 all works fine.