* Re: hwsusp defunct [not found] ` <200702061855.49077.rjw@sisk.pl> @ 2007-02-07 12:06 ` Jiri Slaby 2007-02-07 12:10 ` Luming Yu 0 siblings, 1 reply; 3+ messages in thread From: Jiri Slaby @ 2007-02-07 12:06 UTC (permalink / raw) To: Rafael J. Wysocki; +Cc: Linux Kernel Mailing List, Pavel Machek, linux-acpi Cc: linux-acpi not-cc: linux-pm Rafael J. Wysocki napsal(a): > On Tuesday, 6 February 2007 12:18, Jiri Slaby wrote: >> This is blindly written dmesg after resume. See it whole at [2]: >> Suspending device 0.0 >> ACPI Exception (exoparg2-0442): AE_AML_PACKAGE_LIMIT, Index (000000007) is beyon >> d end of object [20070126] >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.GTM_] >> (Node dfe64fcc), AE_AML_PACKAGE_LIMIT >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.CHN0._ >> GTM] (Node dfe649f0), AE_AML_PACKAGE_LIMIT >> ... >> hda: selected mode 0x45 >> ACPI Error (dsopcode-0481): Attempt to CreateField of length zero [20070126] >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.RATA] >> (Node dfe64ec8), AE_AML_OPERAND_VALUE >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.CHN0.D >> RV1._GTF] (Node dfe64964), AE_AML_OPERAND_VALUE >> do_drive_get_GTF: Run _GTF error: status = 0x3006 > > This looks like an ACPI-vs-IDE problem. You can try to use libata drivers instead > of the "old IDE" ones. > >> $ ls -l /sys/block/hda/device >> lrwxrwxrwx 1 root root 0 úno 6 12:14 /sys/block/hda/device -> >> ../../devices/pci0000:00/0000:00:1f.1/ide0/0.0 >> $ ls -l /sys/block/hda/device/driver >> lrwxrwxrwx 1 root root 0 úno 6 12:15 /sys/block/hda/device/driver -> >> ../../../../../bus/ide/drivers/ide-disk >> $ ls -l /sys/block/hda/device/driver/0.0 >> lrwxrwxrwx 1 root root 0 úno 6 12:16 /sys/block/hda/device/driver/0.0 -> >> ../../../../devices/pci0000:00/0000:00:1f.1/ide0/0.0 >> # lspci -vvvxxs 0000:00:1f.1 >> 00:1f.1 IDE interface: Intel Corporation 82801EB/ER (ICH5/ICH5R) IDE Controller >> (rev 02) (prog-if 8a [Master SecP PriP]) >> Subsystem: ASUSTeK Computer Inc. P5P800-MX Mainboard >> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- >> Stepping- SERR- FastB2B- >> Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- >> <TAbort- <MAbort- >SERR- <PERR- >> Latency: 0 >> Interrupt: pin A routed to IRQ 5 >> Region 0: I/O ports at 01f0 [size=8] >> Region 1: I/O ports at 03f4 [size=1] >> Region 2: I/O ports at 0170 [size=8] >> Region 3: I/O ports at 0374 [size=1] >> Region 4: I/O ports at fc00 [size=16] >> Region 5: Memory at 30100000 (32-bit, non-prefetchable) [size=1K] >> 00: 86 80 db 24 07 00 80 02 02 8a 01 01 00 00 00 00 >> 10: 01 00 00 00 01 00 00 00 01 00 00 00 01 00 00 00 >> 20: 01 fc 00 00 00 00 10 30 00 00 00 00 43 10 a6 80 >> 30: 00 00 00 00 00 00 00 00 00 00 00 00 00 01 00 00 >> >> Do you want acpidump? > > I'm not an ACPI expert, it won't tell me a lot, but perhaps you should add > linux-acpi to the Cc list. ;-) [...] > [1] > http://www.fi.muni.cz/~xslaby/sklad/config-mm > [2] > http://www.fi.muni.cz/~xpapiez/test/dmesg-mm.txt Ok, acpi folks, any suggests? thanks, -- http://www.fi.muni.cz/~xslaby/ Jiri Slaby faculty of informatics, masaryk university, brno, cz e-mail: jirislaby gmail com, gpg pubkey fingerprint: B674 9967 0407 CE62 ACC8 22A0 32CC 55C3 39D4 7A7E ^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: hwsusp defunct 2007-02-07 12:06 ` hwsusp defunct Jiri Slaby @ 2007-02-07 12:10 ` Luming Yu 2007-02-07 13:02 ` Jiri Slaby 0 siblings, 1 reply; 3+ messages in thread From: Luming Yu @ 2007-02-07 12:10 UTC (permalink / raw) To: Jiri Slaby Cc: Rafael J. Wysocki, Linux Kernel Mailing List, Pavel Machek, linux-acpi For acpi issues, please enter bug into bugzilla.kernel.org with dmesg, acpidump output . On 2/7/07, Jiri Slaby <jirislaby@gmail.com> wrote: > Cc: linux-acpi > not-cc: linux-pm > > Rafael J. Wysocki napsal(a): > > On Tuesday, 6 February 2007 12:18, Jiri Slaby wrote: > >> This is blindly written dmesg after resume. See it whole at [2]: > >> Suspending device 0.0 > >> ACPI Exception (exoparg2-0442): AE_AML_PACKAGE_LIMIT, Index (000000007) is beyon > >> d end of object [20070126] > >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.GTM_] > >> (Node dfe64fcc), AE_AML_PACKAGE_LIMIT > >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.CHN0._ > >> GTM] (Node dfe649f0), AE_AML_PACKAGE_LIMIT > >> ... > >> hda: selected mode 0x45 > >> ACPI Error (dsopcode-0481): Attempt to CreateField of length zero [20070126] > >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.RATA] > >> (Node dfe64ec8), AE_AML_OPERAND_VALUE > >> ACPI Error (psparse-0537): Method parse/execution failed [\_SB_.PCI0.IDE0.CHN0.D > >> RV1._GTF] (Node dfe64964), AE_AML_OPERAND_VALUE > >> do_drive_get_GTF: Run _GTF error: status = 0x3006 > > > > This looks like an ACPI-vs-IDE problem. You can try to use libata drivers instead > > of the "old IDE" ones. > > > >> $ ls -l /sys/block/hda/device > >> lrwxrwxrwx 1 root root 0 úno 6 12:14 /sys/block/hda/device -> > >> ../../devices/pci0000:00/0000:00:1f.1/ide0/0.0 > >> $ ls -l /sys/block/hda/device/driver > >> lrwxrwxrwx 1 root root 0 úno 6 12:15 /sys/block/hda/device/driver -> > >> ../../../../../bus/ide/drivers/ide-disk > >> $ ls -l /sys/block/hda/device/driver/0.0 > >> lrwxrwxrwx 1 root root 0 úno 6 12:16 /sys/block/hda/device/driver/0.0 -> > >> ../../../../devices/pci0000:00/0000:00:1f.1/ide0/0.0 > >> # lspci -vvvxxs 0000:00:1f.1 > >> 00:1f.1 IDE interface: Intel Corporation 82801EB/ER (ICH5/ICH5R) IDE Controller > >> (rev 02) (prog-if 8a [Master SecP PriP]) > >> Subsystem: ASUSTeK Computer Inc. P5P800-MX Mainboard > >> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- > >> Stepping- SERR- FastB2B- > >> Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- > >> <TAbort- <MAbort- >SERR- <PERR- > >> Latency: 0 > >> Interrupt: pin A routed to IRQ 5 > >> Region 0: I/O ports at 01f0 [size=8] > >> Region 1: I/O ports at 03f4 [size=1] > >> Region 2: I/O ports at 0170 [size=8] > >> Region 3: I/O ports at 0374 [size=1] > >> Region 4: I/O ports at fc00 [size=16] > >> Region 5: Memory at 30100000 (32-bit, non-prefetchable) [size=1K] > >> 00: 86 80 db 24 07 00 80 02 02 8a 01 01 00 00 00 00 > >> 10: 01 00 00 00 01 00 00 00 01 00 00 00 01 00 00 00 > >> 20: 01 fc 00 00 00 00 10 30 00 00 00 00 43 10 a6 80 > >> 30: 00 00 00 00 00 00 00 00 00 00 00 00 00 01 00 00 > >> > >> Do you want acpidump? > > > > I'm not an ACPI expert, it won't tell me a lot, but perhaps you should add > > linux-acpi to the Cc list. ;-) > [...] > > [1] > > http://www.fi.muni.cz/~xslaby/sklad/config-mm > > [2] > > http://www.fi.muni.cz/~xpapiez/test/dmesg-mm.txt > > Ok, acpi folks, any suggests? > > thanks, > -- > http://www.fi.muni.cz/~xslaby/ Jiri Slaby > faculty of informatics, masaryk university, brno, cz > e-mail: jirislaby gmail com, gpg pubkey fingerprint: > B674 9967 0407 CE62 ACC8 22A0 32CC 55C3 39D4 7A7E > - > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/ > - To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html ^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: hwsusp defunct 2007-02-07 12:10 ` Luming Yu @ 2007-02-07 13:02 ` Jiri Slaby 0 siblings, 0 replies; 3+ messages in thread From: Jiri Slaby @ 2007-02-07 13:02 UTC (permalink / raw) To: Luming Yu Cc: Rafael J. Wysocki, Linux Kernel Mailing List, Pavel Machek, linux-acpi Luming Yu napsal(a): > For acpi issues, please enter bug into bugzilla.kernel.org with dmesg, > acpidump output . Ok: http://bugzilla.kernel.org/show_bug.cgi?id=7958 thanks, -- http://www.fi.muni.cz/~xslaby/ Jiri Slaby faculty of informatics, masaryk university, brno, cz e-mail: jirislaby gmail com, gpg pubkey fingerprint: B674 9967 0407 CE62 ACC8 22A0 32CC 55C3 39D4 7A7E ^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2007-02-07 13:02 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
[not found] <45C5DBBA.20502@gmail.com>
[not found] ` <200702041452.28874.rjw@sisk.pl>
[not found] ` <45C86405.1070902@gmail.com>
[not found] ` <200702061855.49077.rjw@sisk.pl>
2007-02-07 12:06 ` hwsusp defunct Jiri Slaby
2007-02-07 12:10 ` Luming Yu
2007-02-07 13:02 ` Jiri Slaby
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox