Re: [PATCH] spi: Try to get ACPI GPIO IRQ earlier

[Hans de Goede <hansg@kernel.org>]

Hi,

On 3-Nov-25 10:35 AM, Andy Shevchenko wrote:
> On Sun, Nov 02, 2025 at 08:09:21PM +0100, Hans de Goede wrote:
>> Since commit d24cfee7f63d ("spi: Fix acpi deferred irq probe"), the
>> acpi_dev_gpio_irq_get() call gets delayed till spi_probe() is called
>> on the SPI device.
>>
>> If there is no driver for the SPI device then the move to spi_probe()
>> results in acpi_dev_gpio_irq_get() never getting called. This may
>> cause problems by leaving the GPIO pin floating because this call is
>> responsible for setting up the GPIO pin direction and/or bias according
>> to the values from the ACPI tables.
>>
>> Re-add the removed acpi_dev_gpio_irq_get() in acpi_register_spi_device()
>> to ensure the GPIO pin is always correctly setup, while keeping the
>> acpi_dev_gpio_irq_get() call added to spi_probe() to deal with
>> -EPROBE_DEFER returns caused by the GPIO controller not having a driver
>> yet.
> 
> Even before following the link to some papering over module via the link below
> I wondered, if the I²C case should be covered as well. The
> https://github.com/alexpevzner/hotfix-kvadra-touchpad refers to I²C enabled
> touchpads.
> 
>> Link: https://bbs.archlinux.org/viewtopic.php?id=302348
> 
> ...
> 
> I'm not against the SPI fix, but is it confirmed that it really fixes the issue?

Yes Mark and I got an offlist email bisecting this to the:

Fixes: d24cfee7f63d ("spi: Fix acpi deferred irq probe")

commit (on a stable kernel series) and a later email confirming that this
patch fixes it.

It seems that leaving the fingerprint reader enable pin (the first GPIO
listed in _CRS which is an output only pin, is likely the enable pin)
floating is causing these issues. So in a way the acpi_dev_gpio_irq_get()
fixing this by forcing the enable pin to no longer float is a bit of
luck. But things did work before d24cfee7f63d ("spi: Fix acpi deferred irq probe")
so we need this to fix a regression and as you indicate it seems
like a good idea in general and maybe we should also do this for i2c.

As for doing something similar for I2C devices, that is an interesting
question. Even though it is possible I'm not aware of any i2c-devices
which have a userspace driver like SPI/USB fingerprint readers do,
so on i2c I would expect probe() to always get called. So I'm not sure
it is necessary there.

Regards,

Hans