"James A. Goodwin" wrote:

> You say in your message that your router eth0 is 10.1.1.100 but you
> then say that your gateway is set as 10.1.1.1
>
> Shouldn't the gateway be the appropriate router address for that side
> of the network.
>

The 10.1.1.1 gateway specified is actually our firewall on that network which
gets us out to the internet.  If specifying that causes a problem, I can
remove it, because the 192.168.0.0 clients do not need to get to the
internet.  They only need access to the 10.1.1.0 network.

I tried setting the gateway in /etc/sysconfig/network and
/etc/sysconfig/static-routes to 10.1.1.100 which is the router I set up, and
unfortunately I still can't route traffic from 192.168.0.0 to 10.1.1.0.

Thanks,

-Ian



>
> >Hello all.
> >
> >I am a Sun administrator needing to get a router set up on Red Hat 6.2.
> >I am simply trying to join two private networks, 192.168.0.0 and
> >10.1.1.0.  The router I have configured has eth0 at 10.1.1.100 and eth1
> >at 192.168.1.1.  I do not need to be able to route traffic to the
> >internet using NAT -- I only need a DHCP server on my 192.168.0.0
> >network to give out IP addresses on that network (this works fine) that
> >will allow users to access the 10.1.1.0 network.
> >
> >On my router, currently I can ping an address on the 10.1.1.0 network,
> >but not when I use something like ping -I 192.168.1.1 10.1.1.1 to do
> >so.  This should work, right?
> >
> >/etc/sysconfig/network looks like:
> >
> >NETWORKING=yes
> >HOSTNAME=myhost.mydomain
> >GATEWAYDEV=eth0
> >GATEWAY=10.1.1.1
> >FORWARD_IPV4=YES
> >
> >/etc/sysconfig/static-routes has:
> >
> >eth1 net 192.168.0.0 netmask 255.255.0.0 gw 192.168.1.1
> >eth0 net 10.1.1.0 netmask 255.255.255.0 gw 10.1.1.100
> >
> >Can anyone please point out what I am missing or otherwise doing wrong?
> >Even if the answer is "buy a book", a suggestion on which one might help
> >me is welcome also.
> >
> >Again, I don't need to be concerned about NAT, firewalls or security at
> >this point, which is why I haven't touched ipchains for this purpose.  I
> >assume I don't need it only to route traffic between two networks, no?
> >
> >Thanks much in advance!
> >
> >-Ian
> >
> >Content-Type: text/x-vcard; charset=us-ascii;
> >  name="ianz.vcf"
> >Content-Transfer-Encoding: 7bit
> >Content-Description: Card for Ian Zapczynski
> >Content-Disposition: attachment;
> >  filename="ianz.vcf"
> >
> >Attachment converted: Macintosh HD:ianz.vcf (TEXT/ttxt) (00007AA9)
>
> --