From: Matt Turner <mattst88@gmail.com>
To: Richard Henderson <richard.henderson@linaro.org>,
Magnus Lindholm <linmag7@gmail.com>,
Guenter Roeck <linux@roeck-us.net>
Cc: linux-alpha@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-hwmon@vger.kernel.org, linux-doc@vger.kernel.org,
Matt Turner <mattst88@gmail.com>
Subject: [PATCH v3 0/7] alpha: marvel: environmental sensors
Date: Tue, 17 Nov 2026 13:13:27 -0500 [thread overview]
Message-ID: <20261117-marvel-env-v3-0-0edc370fdca9@gmail.com> (raw)
The service processors of the Marvel AlphaServers (GS1280, ES80, ES47)
monitor temperatures, fans, voltages and power supplies. Linux can't read
these sensors, and the events the firmware raises when one changes state
are printed only with CONFIG_VERBOSE_MCHECK, and then decoded wrongly.
Patches 1 and 2 fix the event reporting. Patch 3 adds the SRM callback
that refreshes the readings of one config tree node, patch 4 passes the
firmware's events to a notifier chain, and patch 5 registers a platform
device. Patch 6 is the hwmon driver, which polls, and patch 7 makes it
reread the sensors and notify userspace when the firmware reports an
event.
The hwmon patches depend on the alpha ones, so I'd suggest the whole
series go through the alpha tree with an ack from Guenter.
Tested on an ES47, where sensors(1) shows the temperatures, fans,
voltages and power supply status. Disconnecting AC from one of its two
power supplies raised a system event that set the supply's in_fault and
woke poll() and udev, and reconnecting it cleared the fault the same
way. No voltage is out of range, so the voltage alarms were checked by
forcing the warning and failure states in the console's packets.
I used Claude Code to help write this series: working out the packet
layout, drafting the code and changelogs, and checking the firmware
documentation. I reviewed and tested the result.
Signed-off-by: Matt Turner <mattst88@gmail.com>
---
Changes in v3:
- alpha: put marvel_env_state() under CONFIG_VERBOSE_MCHECK in patch 1,
so that patch builds on its own without it (Magnus)
- alpha: declare srmcons_callback_lock unconditionally and restore the
SRM check in marvel_cfgtree_partial_update(), as in v1, which fixes
the build of a Marvel kernel without SRM support (Magnus, Sashiko)
- hwmon: check the second walk of the config tree against the counts
from the first (Magnus)
- hwmon: prefix every label with the cabinet and drawer if any unit is
outside cabinet 0, drawer 0, as documented (Magnus)
- hwmon: drop the update_interval attribute and refresh a unit at most
once every 10 seconds, since update_interval is for intervals
programmed into the hardware (Guenter)
- Link to v2: https://patch.msgid.link/20261116-marvel-env-v2-0-ef614eb2e7f1@gmail.com
Changes in v2:
- hwmon: report the firmware's states by their documented meaning: a
sensor's warning and failure states are its reading reaching the
warning and failure limits, not a broken sensor (Guenter)
- hwmon: report power supplies as in channels with only a fault
attribute instead of power alarms (Guenter)
- hwmon: depend on !ALPHA_LEGACY_START_ADDRESS for generic kernels,
which leave out core_marvel.o (Sashiko)
- hwmon: drop the private mutex, rely on the hwmon core lock and take
hwmon_lock() in the event work (Sashiko)
- hwmon: notify each alarm attribute whose value changed, and only those
(Sashiko, Magnus)
- hwmon: report a voltage outside its limits as in_min_alarm and
in_lcrit_alarm or in_max_alarm and in_crit_alarm, by comparing it with
the nominal voltage in the console's packet (Guenter, Magnus)
- alpha: define CCB_CFGTREE in asm/console.h instead of the uapi header,
since it is a Marvel console extension, and say it comes from Tru64
(Magnus)
- hwmon: return -ENODATA from every alarm of a sensor that became unknown
- alpha: drop the unreachable SRM check from
marvel_cfgtree_partial_update(), and move the GCT node type and
subtype the driver uses to asm/gct.h
- Reorder: fix the event layout before printing it unconditionally, and
put the alpha patches first
- Drop the Assisted-by trailers, describe tool use here instead (Guenter)
- Link to v1: https://patch.msgid.link/20261114-marvel-env-v1-0-890328e4b7e5@gmail.com
---
Matt Turner (7):
alpha: marvel: fix the environmental subpacket layout
alpha: marvel: report environmental events without VERBOSE_MCHECK
alpha: marvel: refresh environmental readings through the console
alpha: marvel: notify environmental events
alpha: marvel: register a platform device for the environmental sensors
hwmon: Add driver for Marvel AlphaServer environmental sensors
hwmon: (marvel-env) Notify userspace of environmental events
Documentation/hwmon/index.rst | 1 +
Documentation/hwmon/marvel-env.rst | 73 ++++
MAINTAINERS | 8 +
arch/alpha/include/asm/console.h | 5 +
arch/alpha/include/asm/err_ev7.h | 16 +-
arch/alpha/include/asm/gct.h | 2 +
arch/alpha/include/asm/marvel_env.h | 17 +
arch/alpha/kernel/core_marvel.c | 59 ++++
arch/alpha/kernel/err_marvel.c | 39 ++-
arch/alpha/kernel/proto.h | 1 +
arch/alpha/kernel/srmcons.c | 3 +-
arch/alpha/lib/callback_srm.S | 1 +
drivers/hwmon/Kconfig | 12 +
drivers/hwmon/Makefile | 1 +
drivers/hwmon/marvel-env.c | 678 ++++++++++++++++++++++++++++++++++++
15 files changed, 897 insertions(+), 19 deletions(-)
---
base-commit: 0b4cadbe7c39d830dec35c4a2655483de0dae568
change-id: 20261114-marvel-env-d0289c736ba3
Best regards,
--
Matt Turner <mattst88@gmail.com>
next reply other threads:[~2026-11-17 18:13 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-11-17 18:13 Matt Turner [this message]
2026-11-17 18:13 ` [PATCH v3 1/7] alpha: marvel: fix the environmental subpacket layout Matt Turner
2026-11-17 18:13 ` [PATCH v3 2/7] alpha: marvel: report environmental events without VERBOSE_MCHECK Matt Turner
2026-11-17 18:13 ` [PATCH v3 3/7] alpha: marvel: refresh environmental readings through the console Matt Turner
2026-11-17 18:13 ` [PATCH v3 4/7] alpha: marvel: notify environmental events Matt Turner
2026-11-17 18:13 ` [PATCH v3 5/7] alpha: marvel: register a platform device for the environmental sensors Matt Turner
2026-11-17 18:13 ` [PATCH v3 6/7] hwmon: Add driver for Marvel AlphaServer " Matt Turner
2026-11-17 18:13 ` [PATCH v3 7/7] hwmon: (marvel-env) Notify userspace of environmental events Matt Turner
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261117-marvel-env-v3-0-0edc370fdca9@gmail.com \
--to=mattst88@gmail.com \
--cc=linmag7@gmail.com \
--cc=linux-alpha@vger.kernel.org \
--cc=linux-doc@vger.kernel.org \
--cc=linux-hwmon@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@roeck-us.net \
--cc=richard.henderson@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox