[PATCH 3/5] ARM64: dts: meson-gxbb-p20x: add reset for the ethernet PHY

[jbrunet@baylibre.com (Jerome Brunet)]

On Sat, 2016-12-03 at 00:47 +0100, Martin Blumenstingl wrote:
> This resets the ethernet PHY during boot to get the PHY into a
> "clean"
> state. While here also specify the phy-handle of the ethmac node to
> make the PHY configuration similar to the one we have on GXL devices.
> 
> Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.co
> m>
> Tested-by: Neil Armstrong <narmstrong@baylibre.com>
> ---
> ?arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi | 15
> +++++++++++++++
> ?1 file changed, 15 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
> b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
> index 203be28..2abc553 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
> @@ -134,10 +134,25 @@
> ?	pinctrl-names = "default";
> ?};
> ?
> +&mdio0 {
> +	ethernet_phy0: ethernet-phy at 0 {
> +		compatible = "ethernet-phy-ieee802.3-c22";
> +		reg = <0>;

Sorry for the late reply.
I just tried on the p200 and this patch (serie) breaks the network on
it. The PHY is not detected anymore.

>From the KSZ9031 Datasheet : "PHY Address 0h is supported as the unique
PHY address only; it is not supported as the broadcast PHY address
[...]"

So we can't just use the broadcast address here:
reg should be <3>.

> +	};
> +};
> +
> ?&ethmac {
> ?	status = "okay";
> ?	pinctrl-0 = <&eth_rgmii_pins>;
> ?	pinctrl-names = "default";
> +
> +	phy-handle = <&ethernet_phy0>;
> +
> +	snps,reset-gpio = <&gpio GPIOZ_14 0>;
> +	snps,reset-delays-us = <0 10000 1000000>;
> +	snps,reset-active-low;
> +
> +	phy-mode = "rgmii";

We can't define this in p20x. actually the p201 uses an rmii.
I have not idea about gpio reset, or the phy address for the p201.

I suppose it would be better to move this to meson-gxbb_p200.dts

I don't know if anybody has a p201, but until we can confirm a working
Ethernet configuration, we should probably drop it for the p201

Of course the problem was already there before this patch ...

> ?};
> ?
> ?&ir {