From mboxrd@z Thu Jan 1 00:00:00 1970 From: jbrunet@baylibre.com (Jerome Brunet) Date: Thu, 19 Jan 2017 10:47:47 +0100 Subject: [PATCH 0/5] meson-gx: reset RGMII PHYs and configure TX delay In-Reply-To: References: <20161202234739.22929-1-martin.blumenstingl@googlemail.com> Message-ID: <1484819267.26620.75.camel@baylibre.com> To: linus-amlogic@lists.infradead.org List-Id: linus-amlogic.lists.infradead.org On Wed, 2017-01-18 at 20:40 +0100, Martin Blumenstingl wrote: > Kevin, > > On Wed, Jan 18, 2017 at 8:28 PM, Kevin Hilman > wrote: > > > > Martin Blumenstingl writes: > > > > > > > > This partially fixes the 1000Mbit/s ethernet TX throughput issues > > > (on > > > networks which are not affected by the EEE problem, as reported > > > here: > > > > Based on the discussions with Jerome, I'm dropping this series from > > the > > v4.11/dt64 branch for now. > what is you opinion on having the MDIO node in meson-gx (and keeping > GXBB and GXL/GXM consistent) vs not having PHY autodetection for GXBB > (= not having the MDIO in meson-gx)? > I cannot send a v2 until we have a decision for this > > > > > This series also had a small conflict with Jerome's fix[1] for the > > odroid-c2, so please rebase any updates here on my v4.10/fixes > > branch. > will keep that in mind, noted. Most this patch can go away with your patch. Just make sure to keep "eee-broken-1000t;" in the odroidc2 dtsi and it'll be OK. > _______________________________________________ > linux-amlogic mailing list > linux-amlogic at lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-amlogic