[PATCH v2 04/16] mmc: meson-gx: use _irqsave variant of spinlock

[jbrunet@baylibre.com (Jerome Brunet)]

On Tue, 2017-08-22 at 13:08 +0200, Ulf Hansson wrote:
> On 21 August 2017 at 18:02, Jerome Brunet <jbrunet@baylibre.com> wrote:
> > spinlock used in interrupt handler should use the _irqsave variant
> 
> Exactly why is that needed?

That's a mistake left over from a debugging session. Thx for pointing it out.
I'll respin w/o it 

> 
> > 
> > Fixes: 51c5d8447bd7 ("MMC: meson: initial support for GX platforms")
> > Reviewed-by: Kevin Hilman <khilman@baylibre.com>
> > Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
> > ---
> > ?drivers/mmc/host/meson-gx-mmc.c | 5 +++--
> > ?1 file changed, 3 insertions(+), 2 deletions(-)
> > 
> > diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-
> > mmc.c
> > index 8a74a048db88..a399fbd415f4 100644
> > --- a/drivers/mmc/host/meson-gx-mmc.c
> > +++ b/drivers/mmc/host/meson-gx-mmc.c
> > @@ -727,6 +727,7 @@ static irqreturn_t meson_mmc_irq(int irq, void *dev_id)
> > ????????struct mmc_command *cmd;
> > ????????struct mmc_data *data;
> > ????????u32 irq_en, status, raw_status;
> > +???????unsigned long flag;
> > ????????irqreturn_t ret = IRQ_HANDLED;
> > 
> > ????????if (WARN_ON(!host))
> > @@ -739,7 +740,7 @@ static irqreturn_t meson_mmc_irq(int irq, void *dev_id)
> > 
> > ????????data = cmd->data;
> > 
> > -???????spin_lock(&host->lock);
> > +???????spin_lock_irqsave(&host->lock, flag);
> > ????????irq_en = readl(host->regs + SD_EMMC_IRQ_EN);
> > ????????raw_status = readl(host->regs + SD_EMMC_STATUS);
> > ????????status = raw_status & irq_en;
> > @@ -806,7 +807,7 @@ static irqreturn_t meson_mmc_irq(int irq, void *dev_id)
> > ????????if (ret == IRQ_HANDLED)
> > ????????????????meson_mmc_request_done(host->mmc, cmd->mrq);
> > 
> > -???????spin_unlock(&host->lock);
> > +???????spin_unlock_irqrestore(&host->lock, flag);
> > ????????return ret;
> > ?}
> > 
> > --
> > 2.9.5
> > 
> 
> Kind regards
> Uffe