From: Mark Salter <msalter@redhat.com> To: Catalin Marinas <catalin.marinas@arm.com>, Will Deacon <will.deacon@arm.com> Cc: "Arnd Bergmann <arnd@arndb.de>--cc=Ard Biesheuvel" <ard.biesheuvel@linaro.org>, Mark Rutland <mark.rutland@arm.com>, linux-kernel@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-mm@kvack.org, linux-arch@vger.kernel.org, Mark Salter <msalter@redhat.com> Subject: [PATCH 2/2] arm64: support initrd outside kernel linear map Date: Tue, 28 Jul 2015 10:32:41 -0400 [thread overview] Message-ID: <1438093961-15536-3-git-send-email-msalter@redhat.com> (raw) In-Reply-To: <1438093961-15536-1-git-send-email-msalter@redhat.com> The use of mem= could leave part or all of the initrd outside of the kernel linear map. This will lead to an error when unpacking the initrd and a probable failure to boot. This patch catches that situation and relocates the initrd to be fully within the linear map. Signed-off-by: Mark Salter <msalter@redhat.com> --- arch/arm64/kernel/setup.c | 55 +++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 55 insertions(+) diff --git a/arch/arm64/kernel/setup.c b/arch/arm64/kernel/setup.c index f3067d4..96339b5 100644 --- a/arch/arm64/kernel/setup.c +++ b/arch/arm64/kernel/setup.c @@ -359,6 +359,60 @@ static void __init request_standard_resources(void) } } +/* + * Relocate initrd if it is not completely within the linear mapping. + * This would be the case if mem= cuts out all or part of it. + */ +static void __init relocate_initrd(void) +{ +#ifdef CONFIG_BLK_DEV_INITRD + phys_addr_t orig_start = __virt_to_phys(initrd_start); + phys_addr_t orig_end = __virt_to_phys(initrd_end); + phys_addr_t ram_end = memblock_end_of_DRAM(); + phys_addr_t new_start; + unsigned long size, to_free = 0; + void *dest; + + if (orig_end <= ram_end) + return; + + /* Note if any of original initrd will freeing below */ + if (orig_start < ram_end) + to_free = ram_end - orig_start; + + size = orig_end - orig_start; + + /* initrd needs to be relocated completely inside linear mapping */ + new_start = memblock_find_in_range(0, PFN_PHYS(max_pfn), + size, PAGE_SIZE); + if (!new_start) + panic("Cannot relocate initrd of size %ld\n", size); + memblock_reserve(new_start, size); + + initrd_start = __phys_to_virt(new_start); + initrd_end = initrd_start + size; + + pr_info("Moving initrd from [%llx-%llx] to [%llx-%llx]\n", + orig_start, orig_start + size - 1, + new_start, new_start + size - 1); + + dest = (void *)initrd_start; + + if (to_free) { + memcpy(dest, (void *)__phys_to_virt(orig_start), to_free); + dest += to_free; + } + + copy_from_early_mem(dest, orig_start + to_free, size - to_free); + + if (to_free) { + pr_info("Freeing original RAMDISK from [%llx-%llx]\n", + orig_start, orig_start + to_free - 1); + memblock_free(orig_start, to_free); + } +#endif +} + u64 __cpu_logical_map[NR_CPUS] = { [0 ... NR_CPUS-1] = INVALID_HWID }; void __init setup_arch(char **cmdline_p) @@ -392,6 +446,7 @@ void __init setup_arch(char **cmdline_p) acpi_boot_table_init(); paging_init(); + relocate_initrd(); request_standard_resources(); early_ioremap_reset(); -- 2.4.3 -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@kvack.org. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>
WARNING: multiple messages have this Message-ID (diff)
From: Mark Salter <msalter@redhat.com> To: Catalin Marinas <catalin.marinas@arm.com>, Will Deacon <will.deacon@arm.com> Cc: "Arnd Bergmann <arnd@arndb.de>--cc=Ard Biesheuvel" <ard.biesheuvel@linaro.org>, Mark Rutland <mark.rutland@arm.com>, linux-kernel@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-mm@kvack.org, linux-arch@vger.kernel.org, Mark Salter <msalter@redhat.com> Subject: [PATCH 2/2] arm64: support initrd outside kernel linear map Date: Tue, 28 Jul 2015 10:32:41 -0400 [thread overview] Message-ID: <1438093961-15536-3-git-send-email-msalter@redhat.com> (raw) Message-ID: <20150728143241.PR7YQjrfDDJDN7cv2po6Gbox46m78nMeA8ZtmQJdJjo@z> (raw) In-Reply-To: <1438093961-15536-1-git-send-email-msalter@redhat.com> The use of mem= could leave part or all of the initrd outside of the kernel linear map. This will lead to an error when unpacking the initrd and a probable failure to boot. This patch catches that situation and relocates the initrd to be fully within the linear map. Signed-off-by: Mark Salter <msalter@redhat.com> --- arch/arm64/kernel/setup.c | 55 +++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 55 insertions(+) diff --git a/arch/arm64/kernel/setup.c b/arch/arm64/kernel/setup.c index f3067d4..96339b5 100644 --- a/arch/arm64/kernel/setup.c +++ b/arch/arm64/kernel/setup.c @@ -359,6 +359,60 @@ static void __init request_standard_resources(void) } } +/* + * Relocate initrd if it is not completely within the linear mapping. + * This would be the case if mem= cuts out all or part of it. + */ +static void __init relocate_initrd(void) +{ +#ifdef CONFIG_BLK_DEV_INITRD + phys_addr_t orig_start = __virt_to_phys(initrd_start); + phys_addr_t orig_end = __virt_to_phys(initrd_end); + phys_addr_t ram_end = memblock_end_of_DRAM(); + phys_addr_t new_start; + unsigned long size, to_free = 0; + void *dest; + + if (orig_end <= ram_end) + return; + + /* Note if any of original initrd will freeing below */ + if (orig_start < ram_end) + to_free = ram_end - orig_start; + + size = orig_end - orig_start; + + /* initrd needs to be relocated completely inside linear mapping */ + new_start = memblock_find_in_range(0, PFN_PHYS(max_pfn), + size, PAGE_SIZE); + if (!new_start) + panic("Cannot relocate initrd of size %ld\n", size); + memblock_reserve(new_start, size); + + initrd_start = __phys_to_virt(new_start); + initrd_end = initrd_start + size; + + pr_info("Moving initrd from [%llx-%llx] to [%llx-%llx]\n", + orig_start, orig_start + size - 1, + new_start, new_start + size - 1); + + dest = (void *)initrd_start; + + if (to_free) { + memcpy(dest, (void *)__phys_to_virt(orig_start), to_free); + dest += to_free; + } + + copy_from_early_mem(dest, orig_start + to_free, size - to_free); + + if (to_free) { + pr_info("Freeing original RAMDISK from [%llx-%llx]\n", + orig_start, orig_start + to_free - 1); + memblock_free(orig_start, to_free); + } +#endif +} + u64 __cpu_logical_map[NR_CPUS] = { [0 ... NR_CPUS-1] = INVALID_HWID }; void __init setup_arch(char **cmdline_p) @@ -392,6 +446,7 @@ void __init setup_arch(char **cmdline_p) acpi_boot_table_init(); paging_init(); + relocate_initrd(); request_standard_resources(); early_ioremap_reset(); -- 2.4.3
next prev parent reply other threads:[~2015-07-28 14:32 UTC|newest] Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top 2015-07-28 14:32 [PATCH 0/2] arm64: support initrd outside of mapped RAM Mark Salter 2015-07-28 14:32 ` [PATCH 1/2] mm: add utility for early copy from unmapped ram Mark Salter 2015-07-28 14:32 ` Mark Salter 2015-07-28 14:32 ` Mark Salter [this message] 2015-07-28 14:32 ` [PATCH 2/2] arm64: support initrd outside kernel linear map Mark Salter 2015-07-28 14:59 ` [PATCH 0/2] arm64: support initrd outside of mapped RAM Mark Rutland 2015-07-28 15:07 ` Mark Salter 2015-07-28 15:07 ` Mark Salter 2015-07-28 15:14 ` Mark Rutland 2015-07-29 9:20 ` Jon Medhurst (Tixy) 2015-07-29 9:20 ` Jon Medhurst (Tixy) 2015-07-29 9:25 ` Mark Rutland
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=1438093961-15536-3-git-send-email-msalter@redhat.com \ --to=msalter@redhat.com \ --cc=ard.biesheuvel@linaro.org \ --cc=catalin.marinas@arm.com \ --cc=linux-arch@vger.kernel.org \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-mm@kvack.org \ --cc=mark.rutland@arm.com \ --cc=will.deacon@arm.com \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox; as well as URLs for NNTP newsgroup(s).