Re: [PATCH v2 22/22] bitops: remove minix bitops from asm/bitops.h

[Michal Simek <monstr@monstr.eu>]

Akinobu Mita wrote:
> minix bit operations are only used by minix filesystem and useless
> by other modules. Because byte order of inode and block bitmaps is
> defferent on each architecture like below:
> 
> m68k:
> 	big-endian 16bit indexed bitmaps
> 
> h8300, microblaze, s390, sparc, m68knommu:
> 	big-endian 32 or 64bit indexed bitmaps

Just one small fix microblaze little endian support is ready for merging
to mainline which means that microblaze is
big-endian 32bit  and  little-endian 32bit

> 
> m32r, mips, sh, xtensa:
> 	big-endian 32 or 64bit indexed bitmaps for big-endian mode
> 	little-endian bitmaps for little-endian mode
> 
> Others:
> 	little-endian bitmaps
> 
> In order to move minix bit operations from asm/bitops.h to
> architecture independent code in minix file system, this provides two
> config options.
> 
> CONFIG_MINIX_FS_BIG_ENDIAN_16BIT_INDEXED is only selected by m68k.
> CONFIG_MINIX_FS_NATIVE_ENDIAN is selected by the architectures which
> use native byte order bitmaps (h8300, microblaze, s390, sparc,
> m68knommu, m32r, mips, sh, xtensa).
> The architectures which always use little-endian bitmaps do not select
> these options.

I haven't created any Kconfig option for little/big endian microblaze
but there should be a little bit different handling for MINIX_FS_NATIVE_ENDIAN
as you are describing above.
Anyway I think you don't need to reflect this in your patch because
we are not using that filesystem and I will write it to my to-do list and
will fix it later.

Thanks,
Michal

-- 
Michal Simek, Ing. (M.Eng)
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/
Microblaze U-BOOT custodian