From mboxrd@z Thu Jan 1 00:00:00 1970 From: alexanders83@web.de (Alexander Stein) Date: Sun, 13 Apr 2014 10:32:09 +0200 Subject: [PATCH 3/4] ALSA: sound/atmel/ac97c.c: Add device tree support In-Reply-To: <1397299697.719282244@f331.i.mail.ru> References: <1397293707-26890-1-git-send-email-alexanders83@web.de> <5369289.Xz059aMMT6@kongar> <1397299697.719282244@f331.i.mail.ru> Message-ID: <11572820.ByGz2BLudS@kongar> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Saturday 12 April 2014, 14:48:17 wrote Alexander Shiyan: > Sat, 12 Apr 2014 12:42:18 +0200 ?? Alexander Stein : > > On Saturday 12 April 2014, 14:31:28 wrote Alexander Shiyan: > > > Sat, 12 Apr 2014 11:08:26 +0200 ?? Alexander Stein : > > > > Signed-off-by: Alexander Stein > > > > --- > > > > .../devicetree/bindings/sound/atmel_ac97c.txt | 20 +++++++++ > > > > sound/atmel/ac97c.c | 52 ++++++++++++++++++++-- > > > > 2 files changed, 69 insertions(+), 3 deletions(-) > > > > create mode 100644 Documentation/devicetree/bindings/sound/atmel_ac97c.txt > > > > > > > > diff --git a/Documentation/devicetree/bindings/sound/atmel_ac97c.txt b/Documentation/devicetree/bindings/sound/atmel_ac97c.txt > > > > new file mode 100644 > > > > index 0000000..9839403 > > > > --- /dev/null > > > > +++ b/Documentation/devicetree/bindings/sound/atmel_ac97c.txt > > > > @@ -0,0 +1,20 @@ > > > > +* Atmel AC97 controller > > > > + > > > > +Required properties: > > > > + - compatible: "atmel,atmel_ac97c" > > > > + - reg: Address and length of the register set for the device > > > > + - interrupts: Should contain AC97 interrupt > > > > + - atmel,reset-pin: GPIO for resetting the codec > > > > > > Why standard "gpios" property cannot be used here? > > > > I guess they can. I have no experience defining a devicetree binding, so I just stuck to the platformdata member name. > > If this is the recommended way, I'll gladly change that. > > Another question is whether this property should refer to the controller, > as it is clear that it refers to the codec .... AFAICT the codec itself has no representation in the devicetree. It gets detected by the controller which uses the reset GPIO. Alexander