From: "Jernej Škrabec" <jernej.skrabec@gmail.com>
To: Vasily Khoruzhick <anarsoul@gmail.com>,
Yangtao Li <tiny.windzz@gmail.com>,
"Rafael J. Wysocki" <rafael@kernel.org>,
Daniel Lezcano <daniel.lezcano@linaro.org>,
Amit Kucheria <amitk@kernel.org>, Zhang Rui <rui.zhang@intel.com>,
Chen-Yu Tsai <wens@csie.org>,
Samuel Holland <samuel@sholland.org>,
Mark Brown <broonie@kernel.org>
Cc: Hugh Dickins <hughd@google.com>,
linux-pm@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
linux-sunxi@lists.linux.dev, linux-kernel@vger.kernel.org,
Mark Brown <broonie@kernel.org>
Subject: Re: [PATCH v3] thermal/drivers/sun8i: Don't fail probe due to zone registration failure
Date: Fri, 23 Feb 2024 20:51:12 +0100 [thread overview]
Message-ID: <12383045.O9o76ZdvQC@jernej-laptop> (raw)
In-Reply-To: <20240123-thermal-sun8i-registration-v3-1-3e5771b1bbdd@kernel.org>
Hi Daniel, Rafael,
is there any issue with this patch? Can you apply it?
Best regards,
Jernej
Dne sreda, 24. januar 2024 ob 00:33:07 CET je Mark Brown napisal(a):
> Currently the sun8i thermal driver will fail to probe if any of the
> thermal zones it is registering fails to register with the thermal core.
> Since we currently do not define any trip points for the GPU thermal
> zones on at least A64 or H5 this means that we have no thermal support
> on these platforms:
>
> [ 1.698703] thermal_sys: Failed to find 'trips' node
> [ 1.698707] thermal_sys: Failed to find trip points for thermal-sensor id=1
>
> even though the main CPU thermal zone on both SoCs is fully configured.
> This does not seem ideal, while we may not be able to use all the zones
> it seems better to have those zones which are usable be operational.
> Instead just carry on registering zones if we get any non-deferral
> error, allowing use of those zones which are usable.
>
> This means that we also need to update the interrupt handler to not
> attempt to notify the core for events on zones which we have not
> registered, I didn't see an ability to mask individual interrupts and
> I would expect that interrupts would still be indicated in the ISR even
> if they were masked.
>
> Reviewed-by: Vasily Khoruzhick <anarsoul@gmail.com>
> Acked-by: Jernej Skrabec <jernej.skrabec@gmail.com>
> Signed-off-by: Mark Brown <broonie@kernel.org>
> ---
> Changes in v3:
> - Rebase onto v6.8-rc1.
> - Link to v2: https://lore.kernel.org/r/20230912-thermal-sun8i-registration-v2-1-077230107768@kernel.org
>
> Changes in v2:
> - Rebase onto v6.6-rc1.
> - Link to v1: https://lore.kernel.org/r/20230718-thermal-sun8i-registration-v1-1-c95b1b070340@kernel.org
> ---
> drivers/thermal/sun8i_thermal.c | 16 ++++++++++++++--
> 1 file changed, 14 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c
> index 6a8e386dbc8d..c2a8ae7f8f2f 100644
> --- a/drivers/thermal/sun8i_thermal.c
> +++ b/drivers/thermal/sun8i_thermal.c
> @@ -188,6 +188,9 @@ static irqreturn_t sun8i_irq_thread(int irq, void *data)
> int i;
>
> for_each_set_bit(i, &irq_bitmap, tmdev->chip->sensor_num) {
> + /* We allow some zones to not register. */
> + if (IS_ERR(tmdev->sensor[i].tzd))
> + continue;
> thermal_zone_device_update(tmdev->sensor[i].tzd,
> THERMAL_EVENT_UNSPECIFIED);
> }
> @@ -465,8 +468,17 @@ static int sun8i_ths_register(struct ths_device *tmdev)
> i,
> &tmdev->sensor[i],
> &ths_ops);
> - if (IS_ERR(tmdev->sensor[i].tzd))
> - return PTR_ERR(tmdev->sensor[i].tzd);
> +
> + /*
> + * If an individual zone fails to register for reasons
> + * other than probe deferral (eg, a bad DT) then carry
> + * on, other zones might register successfully.
> + */
> + if (IS_ERR(tmdev->sensor[i].tzd)) {
> + if (PTR_ERR(tmdev->sensor[i].tzd) == -EPROBE_DEFER)
> + return PTR_ERR(tmdev->sensor[i].tzd);
> + continue;
> + }
>
> devm_thermal_add_hwmon_sysfs(tmdev->dev, tmdev->sensor[i].tzd);
> }
>
> ---
> base-commit: 6613476e225e090cc9aad49be7fa504e290dd33d
> change-id: 20230718-thermal-sun8i-registration-df3a136ccafa
>
> Best regards,
>
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2024-02-23 19:51 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-01-23 23:33 [PATCH v3] thermal/drivers/sun8i: Don't fail probe due to zone registration failure Mark Brown
2024-02-23 19:51 ` Jernej Škrabec [this message]
2024-02-23 22:27 ` Daniel Lezcano
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=12383045.O9o76ZdvQC@jernej-laptop \
--to=jernej.skrabec@gmail.com \
--cc=amitk@kernel.org \
--cc=anarsoul@gmail.com \
--cc=broonie@kernel.org \
--cc=daniel.lezcano@linaro.org \
--cc=hughd@google.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux-sunxi@lists.linux.dev \
--cc=rafael@kernel.org \
--cc=rui.zhang@intel.com \
--cc=samuel@sholland.org \
--cc=tiny.windzz@gmail.com \
--cc=wens@csie.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox