From mboxrd@z Thu Jan  1 00:00:00 1970
From: schen@mvista.com (Steve Chen)
Date: Tue, 19 Jan 2010 20:21:52 -0600
Subject: make PHYS_OFFSET determined at run time (unfinished)
In-Reply-To: <20100120005505.GD26562@trinity.fluff.org>
References: <20100119083803.GA17904@pengutronix.de>
	<4B561581.6060400@bluewatersys.com>
	<20100120005505.GD26562@trinity.fluff.org>
Message-ID: <1263954112.3207.73.camel@linux-1lbu>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

On Wed, 2010-01-20 at 00:55 +0000, Ben Dooks wrote:
> On Wed, Jan 20, 2010 at 09:26:41AM +1300, Ryan Mallon wrote:
> > Uwe Kleine-K?nig wrote:
> > > Hello,
> > > 
> > > I'm looking into making PHYS_OFFSET determined at run time.  I saw a
> > > patch for it that already made it a few times on the list[1].
> > > 
> > > I'm not yet done, but first want to announce that I look into that to
> > > prevent duplicate work---so if you intended to do the same let's look
> > > together---and to post some clean up patches that are the result up to
> > > now of my digging in the boot code.
> > > 
> > > I will send now three patches in reply to this mail, and later hopefully
> > > more.
> > > 
> > > Best regards
> > > Uwe
> > > 
> > > [1] e.g. http://thread.gmane.org/gmane.linux.ports.arm.kernel/53793/
> > > 
> > 
> > One of the problems that got brought up previously was the 'make uImage'
> > can end up generating unbootable images with runtime PHYS_OFFSET. The
> > older format uImage's (pre 1.3.3) encode a load address (zrealaddr), so
> > uImage's need to have a fixed load address encoded.
> > 
> > As I stated in the previous thread, this is _not_ a kernel issue,
> > however it is no good having a kernel which contains support for two
> > boards which boot from different address and then generating a uImage
> > which can only boot on one of them without warning the user about this
> > problem. Otherwise you are going to start getting "I did make uImage and
> > my board won't boot" problems.
> > 
> > There are a few solutions to this problem:
> > 1) Drop uImage make support and require users generate them manually.
> > 2) Have a uImage offset config option to allow uImage users to specify
> > what they want the load address to be. See:
> > http://thread.gmane.org/gmane.linux.ports.arm.kernel/53151/focus=53230
> > 3) Print an error if "make uImage" is run for a kernel which has more
> > than one boot address (possible?)
> > 4) Use FIT U-Boot images. This is supported from U-Boot 1.3.3 onwards,
> > however a number of people are still using older U-Boots.
> 
> Or of course, boot zImages. I belive u-boot has support for zImage.

Is there a clean way to pass kernel parameters and machine type from
u-boot to zImage?  Last time I boot zImage in u-boot, some ugly hack was
needed in ARM startup code.  Just wondering if there is a better way.

Thanks

Steve