From mboxrd@z Thu Jan 1 00:00:00 1970 From: ben-linux@fluff.org (Ben Dooks) Date: Fri, 29 Jan 2010 04:14:18 +0000 Subject: [PATCH] ARM: SAMSUNG: Use PLAT_SAMSUNG instead of PLAT_S3C In-Reply-To: <1264738459-1972-1-git-send-email-ben-linux@fluff.org> References: <1264738459-1972-1-git-send-email-ben-linux@fluff.org> Message-ID: <1264738459-1972-6-git-send-email-ben-linux@fluff.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org As part of the development process, it is hoped PLAT_S3C is either removed from all of the PLAT_SAMSUNG derived platforms or removed entirely. It is also better to use PLAT_SAMSUNG as this is the current base of all Samsung devices. Change the two places that use PLAT_S3C to use PLAT_SAMSUNG Signed-off-by: Ben Dooks --- drivers/serial/Kconfig | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig index 1d47c77..b2157c3 100644 --- a/drivers/serial/Kconfig +++ b/drivers/serial/Kconfig @@ -447,7 +447,7 @@ config SERIAL_CLPS711X_CONSOLE config SERIAL_SAMSUNG tristate "Samsung SoC serial support" - depends on ARM && PLAT_S3C + depends on ARM && PLAT_SAMSUNG select SERIAL_CORE help Support for the on-chip UARTs on the Samsung S3C24XX series CPUs, @@ -464,7 +464,7 @@ config SERIAL_SAMSUNG_UARTS_4 config SERIAL_SAMSUNG_UARTS int - depends on ARM && PLAT_S3C + depends on ARM && PLAT_SAMSUNG default 2 if ARCH_S3C2400 default 4 if SERIAL_SAMSUNG_UARTS_4 default 3 -- 1.6.0.4