From mboxrd@z Thu Jan 1 00:00:00 1970 From: maramaopercheseimorto@gmail.com (Alberto Panizzo) Date: Tue, 23 Mar 2010 19:49:35 +0100 Subject: [PATCH 2/8] MXC: mach-mx31_3ds: Add support for on board NAND Flash. In-Reply-To: <1269370017.3276.165.camel@realization> References: <1269369741.3276.162.camel@realization> <1269370017.3276.165.camel@realization> Message-ID: <1269370175.3276.168.camel@realization> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Since the using of Bad Block Table is not constantly a good behave I had made it configurable. Signed-off-by: Alberto Panizzo --- arch/arm/mach-mx3/Kconfig | 9 +++++++++ arch/arm/mach-mx3/mach-mx31_3ds.c | 13 +++++++++++++ 2 files changed, 22 insertions(+), 0 deletions(-) diff --git a/arch/arm/mach-mx3/Kconfig b/arch/arm/mach-mx3/Kconfig index 3872af1..9a2911e 100644 --- a/arch/arm/mach-mx3/Kconfig +++ b/arch/arm/mach-mx3/Kconfig @@ -62,6 +62,15 @@ config MACH_MX31_3DS Include support for MX31PDK (3DS) platform. This includes specific configurations for the board and its peripherals. +config MACH_MX31_3DS_MXC_NAND_USE_BBT + bool "Make the MXC NAND driver use the in flash Bad Block Table" + depends on MACH_MX31_3DS + depends on MTD_NAND_MXC + help + Enable this if you want that the MXC NAND driver uses the in flash + Bad Block Table to know what blocks are bad instead of scanning the + entire flash looking for bad block markers. + config MACH_MX31MOBOARD bool "Support mx31moboard platforms (EPFL Mobots group)" select ARCH_MX31 diff --git a/arch/arm/mach-mx3/mach-mx31_3ds.c b/arch/arm/mach-mx3/mach-mx31_3ds.c index 4a94c3c..bf1f54a 100644 --- a/arch/arm/mach-mx3/mach-mx31_3ds.c +++ b/arch/arm/mach-mx3/mach-mx31_3ds.c @@ -34,6 +34,7 @@ #include #include #include +#include #include "devices.h" /*! @@ -53,6 +54,17 @@ static int mx31_3ds_pins[] = { IOMUX_MODE(MX31_PIN_GPIO1_1, IOMUX_CONFIG_GPIO), }; +/* + * NAND Flash + */ +static struct mxc_nand_platform_data imx31_3ds_nand_flash_pdata = { + .width = 1, + .hw_ecc = 1, +#ifdef MACH_MX31_3DS_MXC_NAND_USE_BBT + .flash_bbt = 1, +#endif +}; + static struct imxuart_platform_data uart_pdata = { .flags = IMXUART_HAVE_RTSCTS, }; @@ -236,6 +248,7 @@ static void __init mxc_board_init(void) "mx31_3ds"); mxc_register_device(&mxc_uart_device0, &uart_pdata); + mxc_register_device(&mxc_nand_device, &imx31_3ds_nand_flash_pdata); if (!mx31_3ds_init_expio()) platform_device_register(&smsc911x_device); -- 1.6.3.3