[PATCH 3/6] OMAP3EVM: Update pad configuration for wakeup enabled pads

[khilman@deeprootsystems.com (Kevin Hilman)]

From: Ranjith Lohithakshan <ranjithl@ti.com>

OMAP3530 TRM section 7.4.4.4.2 requires OFFOUTENABLE to be set (active low)
if wakeup capabilities are enabled on a pad. During OFF mode testing
on OMAP3530 EVM, it was observed that the device was not residing in
the OFF state. The device enters into the OFF state and immediately exits
from that state as if an IO wakeup event has occured. The issue was traced
down to the pad configuration of wkaeup enabled pad's.

Signed-off-by: Ranjith Lohithakshan <ranjithl@ti.com>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
---
 arch/arm/mach-omap2/board-omap3evm.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/mach-omap2/board-omap3evm.c b/arch/arm/mach-omap2/board-omap3evm.c
index 017bb2f..3548fb8 100644
--- a/arch/arm/mach-omap2/board-omap3evm.c
+++ b/arch/arm/mach-omap2/board-omap3evm.c
@@ -651,10 +651,10 @@ static struct ehci_hcd_omap_platform_data ehci_pdata __initdata = {
 #ifdef CONFIG_OMAP_MUX
 static struct omap_board_mux board_mux[] __initdata = {
 	OMAP3_MUX(SYS_NIRQ, OMAP_MUX_MODE0 | OMAP_PIN_INPUT_PULLUP |
-				OMAP_PIN_OFF_INPUT_PULLUP |
+				OMAP_PIN_OFF_INPUT_PULLUP | OMAP_PIN_OFF_OUTPUT_LOW |
 				OMAP_PIN_OFF_WAKEUPENABLE),
 	OMAP3_MUX(MCSPI1_CS1, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP |
-				OMAP_PIN_OFF_INPUT_PULLUP |
+				OMAP_PIN_OFF_INPUT_PULLUP | OMAP_PIN_OFF_OUTPUT_LOW |
 				OMAP_PIN_OFF_WAKEUPENABLE),
 	{ .reg_offset = OMAP_MUX_TERMINATOR },
 };
-- 
1.7.0.2