Re: [PATCH] arm64: dts: sun55i: a523: Assign standard clock rates to PRCM bus clocks

["Jernej Škrabec" <jernej.skrabec@gmail.com>]

Dne sobota, 13. september 2025 ob 12:16:00 Srednjeevropski poletni čas je Chen-Yu Tsai napisal(a):
> From: Chen-Yu Tsai <wens@csie.org>
> 
> At least in the initial version of U-boot support landed upstream, the
> PRCM bus clocks were not configured, and left at their reset default 24
> MHz clock rate. This is quite slow for the peripherals on them.
> 
> The recommended rates from the manual are:
> 
> - AHBS: 200 MHz
> - APBS0: 100 MHz
> - APBS1: 24 MHz
> 
> Since 24 MHz is the hardware default, just assign rates for the first two.

I think it's better to be explicit than assume. However, this is fine too.

Reviewed-by: Jernej Skrabec <jernej.skrabec@gmail.com>

Best regards,
Jernej

> 
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>
> ---
>  arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi b/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
> index 3aad1b909501..5cd6ddae86c8 100644
> --- a/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
> +++ b/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
> @@ -767,6 +767,8 @@ r_ccu: clock-controller@7010000 {
>  				      "pll-audio";
>  			#clock-cells = <1>;
>  			#reset-cells = <1>;
> +			assigned-clocks = <&r_ccu CLK_R_AHB>, <&r_ccu CLK_R_APB0>;
> +			assigned-clock-rates = <200000000>, <100000000>;
>  		};
>  
>  		nmi_intc: interrupt-controller@7010320 {
>