From: eric@eukrea.com (Eric Bénard)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH] imx_keypad: add PM support
Date: Sun, 30 May 2010 10:51:06 +0200 [thread overview]
Message-ID: <1275209466-3899-1-git-send-email-eric@eukrea.com> (raw)
In-Reply-To: <1275135823.3128.15.camel@realization>
* add suspend/resume support
* use keypad_data to enable wakeup from platform data
* suspend/resume tested when keypad is not in use and when it's
is use (in which case we immediatly get the key pressed for
wakeup)
Signed-off-by: Eric B?nard <eric@eukrea.com>
---
drivers/input/keyboard/imx_keypad.c | 56 +++++++++++++++++++++++++++++++++-
1 files changed, 54 insertions(+), 2 deletions(-)
diff --git a/drivers/input/keyboard/imx_keypad.c b/drivers/input/keyboard/imx_keypad.c
index d92c15c..b303cc9 100644
--- a/drivers/input/keyboard/imx_keypad.c
+++ b/drivers/input/keyboard/imx_keypad.c
@@ -364,6 +364,55 @@ static void imx_keypad_inhibit(struct imx_keypad *keypad)
writew(0xff00, keypad->mmio_base + KPCR);
}
+static int mxc_kpp_suspend(struct platform_device *pdev, pm_message_t state)
+{
+ struct imx_keypad *keypad = platform_get_drvdata(pdev);
+ unsigned short reg_val;
+
+ clk_disable(keypad->clk);
+
+ if (device_may_wakeup(&pdev->dev)) {
+ reg_val = readw(keypad->mmio_base + KPSR);
+ if ((reg_val & KBD_STAT_KDIE) == 0) {
+ /* If no depress interrupt enable the release interrupt */
+ reg_val |= KBD_STAT_KRIE;
+ writew(reg_val, keypad->mmio_base + KPSR);
+ }
+ enable_irq_wake(keypad->irq);
+ } else {
+ keypad->enabled = false;
+ synchronize_irq(keypad->irq);
+ disable_irq(keypad->irq);
+ }
+
+ return 0;
+}
+
+/*!
+ * This function brings the Keypad controller back from low-power state.
+ * If Keypad is enabled as a wake source(i.e. it can resume the system
+ * from suspend mode), the Keypad controller doesn't enter low-power state.
+ *
+ * @param pdev the device structure used to give information on Keypad
+ * to resume
+ *
+ * @return The function always returns 0.
+ */
+static int mxc_kpp_resume(struct platform_device *pdev)
+{
+ struct imx_keypad *keypad = platform_get_drvdata(pdev);
+
+ clk_enable(keypad->clk);
+ if (device_may_wakeup(&pdev->dev)) {
+ /* The irq routine already cleared KRIE if it was set */
+ } else {
+ keypad->enabled = true;
+ enable_irq(keypad->irq);
+ }
+
+ return 0;
+}
+
static void imx_keypad_close(struct input_dev *dev)
{
struct imx_keypad *keypad = input_get_drvdata(dev);
@@ -410,7 +459,8 @@ open_err:
static int __devinit imx_keypad_probe(struct platform_device *pdev)
{
- const struct matrix_keymap_data *keymap_data = pdev->dev.platform_data;
+ const struct matrix_keypad_platform_data *keypad_data = pdev->dev.platform_data;
+ const struct matrix_keymap_data *keymap_data = keypad_data->keymap_data;
struct imx_keypad *keypad;
struct input_dev *input_dev;
struct resource *res;
@@ -525,7 +575,7 @@ static int __devinit imx_keypad_probe(struct platform_device *pdev)
}
platform_set_drvdata(pdev, keypad);
- device_init_wakeup(&pdev->dev, 1);
+ device_init_wakeup(&pdev->dev, keypad_data->wakeup);
return 0;
@@ -574,6 +624,8 @@ static struct platform_driver imx_keypad_driver = {
},
.probe = imx_keypad_probe,
.remove = __devexit_p(imx_keypad_remove),
+ .suspend = mxc_kpp_suspend,
+ .resume = mxc_kpp_resume,
};
static int __init imx_keypad_init(void)
--
1.6.3.3
next prev parent reply other threads:[~2010-05-30 8:51 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-05-27 6:33 [PATCH v2 1/8] i.MX27: add suspend to RAM support Eric Bénard
2010-05-27 6:33 ` [PATCH v2 2/8] mxc_nand: fix PM Eric Bénard
2010-05-27 6:33 ` [PATCH v2 3/8] imx_keypad: add PM support Eric Bénard
2010-05-27 6:33 ` [PATCH v2 4/8] eukrea_mbimx27: update keyboard platform data Eric Bénard
2010-05-27 6:33 ` [PATCH v2 5/8] serial/imx.c: fix suspend/resume Eric Bénard
2010-05-27 6:33 ` [PATCH v2 6/8] serial/imx: drvdata is sport and not &sport->port Eric Bénard
2010-05-27 6:33 ` [PATCH v2 7/8] net/fec: fix pm to survive to suspend/resume Eric Bénard
2010-05-27 6:33 ` [PATCH v2 8/8] imxfb: fix PM Eric Bénard
2010-05-27 10:37 ` [PATCH v2 7/8] net/fec: fix pm to survive to suspend/resume Sergei Shtylyov
2010-05-27 14:19 ` [PATCH v3] " Eric Bénard
2010-05-27 17:09 ` Fabio Estevam
2010-05-27 17:53 ` [PATCH] " Eric Bénard
2010-05-29 7:15 ` David Miller
2010-05-29 20:04 ` [PATCH v2] " Eric Bénard
2010-06-02 13:13 ` David Miller
2010-05-29 12:23 ` [PATCH v2 3/8] imx_keypad: add PM support Alberto Panizzo
2010-05-30 8:51 ` Eric Bénard [this message]
2010-06-02 8:02 ` [PATCH] " Dmitry Torokhov
2010-05-27 17:55 ` [PATCH] mxc_nand: fix PM Eric Bénard
2010-06-14 7:07 ` Eric Bénard
2010-06-29 6:41 ` Artem Bityutskiy
2010-07-01 3:47 ` Artem Bityutskiy
2010-06-14 8:43 ` Uwe Kleine-König
2010-05-27 14:13 ` [PATCH v3] i.MX27: add suspend to RAM support Eric Bénard
2010-05-27 19:43 ` Russell King - ARM Linux
2010-05-27 20:06 ` Eric Bénard
2010-05-27 20:16 ` Russell King - ARM Linux
2010-05-27 20:48 ` [PATCH v4] " Eric Bénard
2010-05-27 20:54 ` [PATCH v3] " Eric Bénard
2010-05-27 21:46 ` Russell King - ARM Linux
2010-06-01 19:57 ` [PATCH v5] " Eric Bénard
2010-06-03 8:28 ` Sascha Hauer
2010-05-27 21:13 ` [PATCH v3] " Wolfram Sang
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1275209466-3899-1-git-send-email-eric@eukrea.com \
--to=eric@eukrea.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).