[PATCH v2 0/4] tidspbridge: SCM layer violation fixes

[omar.ramirez@ti.com (Omar Ramirez Luna)]

This is the patch series shared by Paul, for a short term fix to
a compile break due SCM layer layer violations from tidspbridge
driver, where the latter is used to write directly into registers
and use SCM layer macros, among other layer bypassing.

patch: "staging: tidspbridge: use new SCM DSP boot control fns"
was split from its original version, it is meant to be on hold until
the rest of the series gets upstreamed and can be found in the
staging tree (unless best advice is given).

Paul Walmsley (4):
  OMAP: control: add functions for DSP boot address/mode control
  OMAP3: PM: update DSP reset code to use new SCM DSP boot control
    functions
  OMAP: dsp: convert OMAP3430 adaptation layer to use new SCM DSP boot
    control fns
  staging: tidspbridge: use new SCM DSP boot control fns

 arch/arm/mach-omap2/control.c                 |   51 ++++++++++++++++++++++
 arch/arm/mach-omap2/control.h                 |   16 ++++---
 arch/arm/mach-omap2/dsp.c                     |    4 ++
 arch/arm/mach-omap2/pm34xx.c                  |    6 +-
 arch/arm/plat-omap/include/plat/dsp.h         |    4 ++
 arch/arm/plat-omap/include/plat/iva2_dsp.h    |   56 +++++++++++++++++++++++++
 drivers/staging/tidspbridge/core/tiomap3430.c |   13 +++---
 7 files changed, 133 insertions(+), 17 deletions(-)
 create mode 100644 arch/arm/plat-omap/include/plat/iva2_dsp.h