From: w.sang@pengutronix.de (Wolfram Sang)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 3/5] mmc: sdhci-esdhc-imx: add card detect on custom GPIO
Date: Wed, 23 Feb 2011 14:51:56 +0100 [thread overview]
Message-ID: <1298469118-25282-4-git-send-email-w.sang@pengutronix.de> (raw)
In-Reply-To: <1298469118-25282-1-git-send-email-w.sang@pengutronix.de>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Tested-by: Marc Reilly <marc@cpdesign.com.au>
Tested-by: Eric Benard <eric@eukrea.com>
---
change since last version:
* improve kerneldoc
* intercept SDHCI_SIGNAL_ENABLE, too (mx25)
* remove BROKEN_CARD_DETECTION as default quirk
arch/arm/plat-mxc/include/mach/esdhc.h | 2 +
drivers/mmc/host/sdhci-esdhc-imx.c | 79 +++++++++++++++++++++++++++++++-
2 files changed, 79 insertions(+), 2 deletions(-)
diff --git a/arch/arm/plat-mxc/include/mach/esdhc.h b/arch/arm/plat-mxc/include/mach/esdhc.h
index 47da109..86003f4 100644
--- a/arch/arm/plat-mxc/include/mach/esdhc.h
+++ b/arch/arm/plat-mxc/include/mach/esdhc.h
@@ -16,9 +16,11 @@
* strongly recommended for i.MX25/35, not needed for other variants
*
* @wp_gpio: gpio for write_protect (-EINVAL if unused)
+ * @cd_gpio: gpio for card_detect interrupt (-EINVAL if unused)
*/
struct esdhc_platform_data {
unsigned int wp_gpio;
+ unsigned int cd_gpio;
};
#endif /* __ASM_ARCH_IMX_ESDHC_H */
diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index 49c9801..353fc63 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -32,6 +32,39 @@ static inline void esdhc_clrset_le(struct sdhci_host *host, u32 mask, u32 val, i
writel(((readl(base) & ~(mask << shift)) | (val << shift)), base);
}
+static u32 esdhc_readl_le(struct sdhci_host *host, int reg)
+{
+ /* fake CARD_PRESENT flag on mx25/35 */
+ u32 val = readl(host->ioaddr + reg);
+
+ if (unlikely(reg == SDHCI_PRESENT_STATE)) {
+ struct esdhc_platform_data *boarddata =
+ host->mmc->parent->platform_data;
+
+ if (boarddata && gpio_is_valid(boarddata->cd_gpio)
+ && gpio_get_value(boarddata->cd_gpio))
+ /* no card, if a valid gpio says so... */
+ val &= SDHCI_CARD_PRESENT;
+ else
+ /* ... in all other cases assume card is present */
+ val |= SDHCI_CARD_PRESENT;
+ }
+
+ return val;
+}
+
+static void esdhc_writel_le(struct sdhci_host *host, u32 val, int reg)
+{
+ if (unlikely(reg == SDHCI_INT_ENABLE || reg == SDHCI_SIGNAL_ENABLE))
+ /*
+ * these interrupts won't work with a custom card_detect gpio
+ * (only applied to mx25/35)
+ */
+ val &= ~(SDHCI_INT_CARD_REMOVE | SDHCI_INT_CARD_INSERT);
+
+ writel(val, host->ioaddr + reg);
+}
+
static u16 esdhc_readw_le(struct sdhci_host *host, int reg)
{
if (unlikely(reg == SDHCI_HOST_VERSION))
@@ -121,6 +154,14 @@ static struct sdhci_ops sdhci_esdhc_ops = {
.get_min_clock = esdhc_pltfm_get_min_clock,
};
+static irqreturn_t cd_irq(int irq, void *data)
+{
+ struct sdhci_host *sdhost = (struct sdhci_host *)data;
+
+ tasklet_schedule(&sdhost->card_tasklet);
+ return IRQ_HANDLED;
+};
+
static int esdhc_pltfm_init(struct sdhci_host *host, struct sdhci_pltfm_data *pdata)
{
struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
@@ -142,6 +183,8 @@ static int esdhc_pltfm_init(struct sdhci_host *host, struct sdhci_pltfm_data *pd
if (cpu_is_mx25() || cpu_is_mx35()) {
/* Fix errata ENGcm07207 present on i.MX25 and i.MX35 */
host->quirks |= SDHCI_QUIRK_NO_MULTIBLOCK;
+ /* card_detect can't be routed to controller, mark broken */
+ host->quirks |= SDHCI_QUIRK_BROKEN_CARD_DETECTION;
/* write_protect can't be routed to controller, use gpio */
sdhci_esdhc_ops.get_ro = esdhc_pltfm_get_ro;
}
@@ -153,9 +196,35 @@ static int esdhc_pltfm_init(struct sdhci_host *host, struct sdhci_pltfm_data *pd
"no write-protect pin available!\n");
boarddata->wp_gpio = err;
}
+
+ err = gpio_request_one(boarddata->cd_gpio, GPIOF_IN, "ESDHC_CD");
+ if (err) {
+ dev_warn(mmc_dev(host->mmc),
+ "no card-detect pin available!\n");
+ goto no_card_detect_pin;
+ }
+
+ err = request_irq(gpio_to_irq(boarddata->cd_gpio), cd_irq,
+ IRQF_TRIGGER_FALLING | IRQF_TRIGGER_RISING,
+ mmc_hostname(host->mmc), host);
+ if (err) {
+ dev_warn(mmc_dev(host->mmc), "request irq error\n");
+ goto no_card_detect_irq;
+ }
+
+ sdhci_esdhc_ops.write_l = esdhc_writel_le;
+ sdhci_esdhc_ops.read_l = esdhc_readl_le;
+ /* Now we have a working card_detect again */
+ host->quirks &= ~SDHCI_QUIRK_BROKEN_CARD_DETECTION;
}
return 0;
+
+ no_card_detect_irq:
+ gpio_free(boarddata->cd_gpio);
+ no_card_detect_pin:
+ boarddata->cd_gpio = err;
+ return 0;
}
static void esdhc_pltfm_exit(struct sdhci_host *host)
@@ -166,13 +235,19 @@ static void esdhc_pltfm_exit(struct sdhci_host *host)
if (boarddata && gpio_is_valid(boarddata->wp_gpio))
gpio_free(boarddata->wp_gpio);
+ if (boarddata && gpio_is_valid(boarddata->cd_gpio)) {
+ gpio_free(boarddata->cd_gpio);
+
+ if (!(host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION))
+ free_irq(gpio_to_irq(boarddata->cd_gpio), host);
+ }
+
clk_disable(pltfm_host->clk);
clk_put(pltfm_host->clk);
}
struct sdhci_pltfm_data sdhci_esdhc_imx_pdata = {
- .quirks = ESDHC_DEFAULT_QUIRKS | SDHCI_QUIRK_BROKEN_ADMA
- | SDHCI_QUIRK_BROKEN_CARD_DETECTION,
+ .quirks = ESDHC_DEFAULT_QUIRKS | SDHCI_QUIRK_BROKEN_ADMA,
/* ADMA has issues. Might be fixable */
.ops = &sdhci_esdhc_ops,
.init = esdhc_pltfm_init,
--
1.7.2.3
next prev parent reply other threads:[~2011-02-23 13:51 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-02-23 13:51 [PATCH V3 0/5] sdhci-esdhc-imx: use gpio for write protection and card detection Wolfram Sang
2011-02-23 13:51 ` [PATCH 1/5] mmc: sdhci-esdhc-imx: add support for write protect on custom GPIO Wolfram Sang
2011-02-23 13:51 ` [PATCH 2/5] mmc: sdhci-esdhc: broken card detection is not a default quirk Wolfram Sang
2011-02-23 13:51 ` Wolfram Sang [this message]
2011-02-23 13:51 ` [PATCH 4/5] arm: mach-mx3: pcm043: add write-protect and card-detect for SD1 Wolfram Sang
2011-02-23 13:51 ` [PATCH 5/5] arm: mach-mx3: use IMX_GPIO_NR instead of hard-coded values Wolfram Sang
2011-02-24 8:18 ` [PATCH V3 0/5] sdhci-esdhc-imx: use gpio for write protection and card detection Shawn Guo
2011-02-24 15:51 ` Shawn Guo
2011-02-24 16:03 ` Shawn Guo
2011-02-24 19:45 ` Wolfram Sang
2011-02-24 11:40 ` Arnaud Patard (Rtp)
2011-02-24 13:12 ` Wolfram Sang
2011-02-24 19:00 ` Eric Benard
2011-02-25 19:31 ` Arnaud Patard (Rtp)
2011-02-25 21:29 ` Eric Benard
-- strict thread matches above, loose matches on Subject: below --
2011-02-22 12:58 [PATCH V2 " Wolfram Sang
2011-02-22 12:58 ` [PATCH 3/5] mmc: sdhci-esdhc-imx: add card detect on custom GPIO Wolfram Sang
2011-02-10 19:14 [PATCH 0/5] sdhci-esdhc-imx: use gpio for write protection and card detection Wolfram Sang
2011-02-10 19:14 ` [PATCH 3/5] mmc: sdhci-esdhc-imx: add card detect on custom GPIO Wolfram Sang
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1298469118-25282-4-git-send-email-w.sang@pengutronix.de \
--to=w.sang@pengutronix.de \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).