linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: catalin.marinas@arm.com (Catalin Marinas)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v5 05/19] ARM: LPAE: Use PMD_(SHIFT|SIZE|MASK) instead of PGDIR_*
Date: Sun,  8 May 2011 13:51:24 +0100	[thread overview]
Message-ID: <1304859098-10760-6-git-send-email-catalin.marinas@arm.com> (raw)
In-Reply-To: <1304859098-10760-1-git-send-email-catalin.marinas@arm.com>

PGDIR_SHIFT and PMD_SHIFT for the classic 2-level page table format have
the same value (21). This patch converts the PGDIR_* uses in the kernel
to the PMD_* equivalent so that LPAE builds can reuse the same code.

Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
---
 arch/arm/kernel/module.c  |    2 +-
 arch/arm/mm/dma-mapping.c |    6 +++---
 arch/arm/mm/mmu.c         |   10 +++++-----
 3 files changed, 9 insertions(+), 9 deletions(-)

diff --git a/arch/arm/kernel/module.c b/arch/arm/kernel/module.c
index fee7c36..116016d 100644
--- a/arch/arm/kernel/module.c
+++ b/arch/arm/kernel/module.c
@@ -33,7 +33,7 @@
  * recompiling the whole kernel when CONFIG_XIP_KERNEL is turned on/off.
  */
 #undef MODULES_VADDR
-#define MODULES_VADDR	(((unsigned long)_etext + ~PGDIR_MASK) & PGDIR_MASK)
+#define MODULES_VADDR	(((unsigned long)_etext + ~PMD_MASK) & PMD_MASK)
 #endif
 
 #ifdef CONFIG_MMU
diff --git a/arch/arm/mm/dma-mapping.c b/arch/arm/mm/dma-mapping.c
index 82a093c..334e9af 100644
--- a/arch/arm/mm/dma-mapping.c
+++ b/arch/arm/mm/dma-mapping.c
@@ -121,8 +121,8 @@ static void __dma_free_buffer(struct page *page, size_t size)
 #endif
 
 #define CONSISTENT_OFFSET(x)	(((unsigned long)(x) - CONSISTENT_BASE) >> PAGE_SHIFT)
-#define CONSISTENT_PTE_INDEX(x) (((unsigned long)(x) - CONSISTENT_BASE) >> PGDIR_SHIFT)
-#define NUM_CONSISTENT_PTES (CONSISTENT_DMA_SIZE >> PGDIR_SHIFT)
+#define CONSISTENT_PTE_INDEX(x) (((unsigned long)(x) - CONSISTENT_BASE) >> PMD_SHIFT)
+#define NUM_CONSISTENT_PTES (CONSISTENT_DMA_SIZE >> PMD_SHIFT)
 
 /*
  * These are the page tables (2MB each) covering uncached, DMA consistent allocations
@@ -181,7 +181,7 @@ static int __init consistent_init(void)
 		}
 
 		consistent_pte[i++] = pte;
-		base += (1 << PGDIR_SHIFT);
+		base += (1 << PMD_SHIFT);
 	} while (base < CONSISTENT_END);
 
 	return ret;
diff --git a/arch/arm/mm/mmu.c b/arch/arm/mm/mmu.c
index 6cf76b3..a855648 100644
--- a/arch/arm/mm/mmu.c
+++ b/arch/arm/mm/mmu.c
@@ -864,14 +864,14 @@ static inline void prepare_page_table(void)
 	/*
 	 * Clear out all the mappings below the kernel image.
 	 */
-	for (addr = 0; addr < MODULES_VADDR; addr += PGDIR_SIZE)
+	for (addr = 0; addr < MODULES_VADDR; addr += PMD_SIZE)
 		pmd_clear(pmd_off_k(addr));
 
 #ifdef CONFIG_XIP_KERNEL
 	/* The XIP kernel is mapped in the module area -- skip over it */
-	addr = ((unsigned long)_etext + PGDIR_SIZE - 1) & PGDIR_MASK;
+	addr = ((unsigned long)_etext + PMD_SIZE - 1) & PMD_MASK;
 #endif
-	for ( ; addr < PAGE_OFFSET; addr += PGDIR_SIZE)
+	for ( ; addr < PAGE_OFFSET; addr += PMD_SIZE)
 		pmd_clear(pmd_off_k(addr));
 
 	/*
@@ -886,7 +886,7 @@ static inline void prepare_page_table(void)
 	 * memory bank, up to the end of the vmalloc region.
 	 */
 	for (addr = __phys_to_virt(end);
-	     addr < VMALLOC_END; addr += PGDIR_SIZE)
+	     addr < VMALLOC_END; addr += PMD_SIZE)
 		pmd_clear(pmd_off_k(addr));
 }
 
@@ -927,7 +927,7 @@ static void __init devicemaps_init(struct machine_desc *mdesc)
 	 */
 	vectors_page = early_alloc(PAGE_SIZE);
 
-	for (addr = VMALLOC_END; addr; addr += PGDIR_SIZE)
+	for (addr = VMALLOC_END; addr; addr += PMD_SIZE)
 		pmd_clear(pmd_off_k(addr));
 
 	/*

  parent reply	other threads:[~2011-05-08 12:51 UTC|newest]

Thread overview: 52+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2011-05-08 12:51 [PATCH v5 00/19] ARM: Add support for the Large Physical Address Extensions Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 01/19] ARM: LPAE: Use long long printk format for displaying the pud Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 02/19] ARM: LPAE: add ISBs around MMU enabling code Catalin Marinas
2011-05-08 21:41   ` Russell King - ARM Linux
2011-05-09 10:22     ` Catalin Marinas
2011-05-09 10:32       ` Russell King - ARM Linux
2011-05-09 10:59         ` Catalin Marinas
2011-05-09 12:05           ` Russell King - ARM Linux
2011-05-09 13:36             ` Catalin Marinas
2011-05-09 15:01             ` Catalin Marinas
2011-05-09 15:34               ` Russell King - ARM Linux
2011-05-09 15:38                 ` Catalin Marinas
2011-05-09 15:48                 ` Russell King - ARM Linux
2011-05-09 16:02                   ` Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 03/19] ARM: LPAE: Use unsigned long for __phys_to_virt and __virt_to_phys Catalin Marinas
2011-05-08 21:44   ` Russell King - ARM Linux
2011-05-16 17:28     ` Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 04/19] ARM: LPAE: Make TTBR1 always point to swapper_pg_dir on ARMv7 Catalin Marinas
2011-05-08 12:51 ` Catalin Marinas [this message]
2011-05-08 12:51 ` [PATCH v5 06/19] ARM: LPAE: Factor out 2-level page table definitions into separate files Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 07/19] ARM: LPAE: Add (pte|pmd|pgd|pgprot)val_t type definitions as u32 Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 08/19] ARM: LPAE: Use a mask for physical addresses in page table entries Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 09/19] ARM: LPAE: Introduce the 3-level page table format definitions Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 10/19] ARM: LPAE: Page table maintenance for the 3-level format Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 11/19] ARM: LPAE: MMU setup for the 3-level page table format Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 12/19] ARM: LPAE: Add fault handling support Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 13/19] ARM: LPAE: Add context switching support Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 14/19] ARM: LPAE: Add identity mapping support for the 3-level page table format Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 15/19] ARM: LPAE: Add support for cpu_v7_do_(suspend|resume) Catalin Marinas
2011-05-18  7:27   ` Tony Lindgren
2011-05-20 13:21     ` Catalin Marinas
2011-05-20 15:17       ` Jean-Christophe PLAGNIOL-VILLARD
2011-05-20 18:09       ` Nicolas Pitre
2011-05-22 21:09         ` Catalin Marinas
2011-05-24  6:26           ` Tony Lindgren
2011-05-08 12:51 ` [PATCH v5 16/19] ARM: LPAE: Use generic dma_addr_t type definition Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 17/19] ARM: LPAE: mark memory banks with start > ULONG_MAX as highmem Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 18/19] ARM: LPAE: add support for ATAG_MEM64 Catalin Marinas
2011-05-08 12:51 ` [PATCH v5 19/19] ARM: LPAE: Add the Kconfig entries Catalin Marinas
2011-05-11 10:23 ` [PATCH 20/19] ARM: LPAE: Invalidate the TLB before freeing the PMD Catalin Marinas
2011-05-11 10:31   ` Sergei Shtylyov
2011-05-11 10:40     ` Catalin Marinas
2011-05-11 10:54   ` Russell King - ARM Linux
2011-05-11 13:40     ` Catalin Marinas
2011-05-11 14:00       ` Russell King - ARM Linux
2011-05-11 15:58         ` Catalin Marinas
2011-05-23 16:54 ` [PATCH v5 00/19] ARM: Add support for the Large Physical Address Extensions Russell King - ARM Linux
2011-05-23 17:22   ` Catalin Marinas
2011-05-24 10:04   ` Catalin Marinas
2011-05-26 21:15     ` Catalin Marinas
2011-05-26 21:44       ` Russell King - ARM Linux
2011-05-27  9:09         ` Catalin Marinas

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1304859098-10760-6-git-send-email-catalin.marinas@arm.com \
    --to=catalin.marinas@arm.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).