From: catalin.marinas@arm.com (Catalin Marinas)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH v6 04/18] ARM: LPAE: Use PMD_(SHIFT|SIZE|MASK) instead of PGDIR_*
Date: Tue, 24 May 2011 22:39:10 +0100 [thread overview]
Message-ID: <1306273164-18217-5-git-send-email-catalin.marinas@arm.com> (raw)
In-Reply-To: <1306273164-18217-1-git-send-email-catalin.marinas@arm.com>
PGDIR_SHIFT and PMD_SHIFT for the classic 2-level page table format have
the same value (21). This patch converts the PGDIR_* uses in the kernel
to the PMD_* equivalent so that LPAE builds can reuse the same code.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
---
arch/arm/kernel/module.c | 2 +-
arch/arm/mm/dma-mapping.c | 6 +++---
arch/arm/mm/mmu.c | 10 +++++-----
3 files changed, 9 insertions(+), 9 deletions(-)
diff --git a/arch/arm/kernel/module.c b/arch/arm/kernel/module.c
index fee7c36..116016d 100644
--- a/arch/arm/kernel/module.c
+++ b/arch/arm/kernel/module.c
@@ -33,7 +33,7 @@
* recompiling the whole kernel when CONFIG_XIP_KERNEL is turned on/off.
*/
#undef MODULES_VADDR
-#define MODULES_VADDR (((unsigned long)_etext + ~PGDIR_MASK) & PGDIR_MASK)
+#define MODULES_VADDR (((unsigned long)_etext + ~PMD_MASK) & PMD_MASK)
#endif
#ifdef CONFIG_MMU
diff --git a/arch/arm/mm/dma-mapping.c b/arch/arm/mm/dma-mapping.c
index 82a093c..334e9af 100644
--- a/arch/arm/mm/dma-mapping.c
+++ b/arch/arm/mm/dma-mapping.c
@@ -121,8 +121,8 @@ static void __dma_free_buffer(struct page *page, size_t size)
#endif
#define CONSISTENT_OFFSET(x) (((unsigned long)(x) - CONSISTENT_BASE) >> PAGE_SHIFT)
-#define CONSISTENT_PTE_INDEX(x) (((unsigned long)(x) - CONSISTENT_BASE) >> PGDIR_SHIFT)
-#define NUM_CONSISTENT_PTES (CONSISTENT_DMA_SIZE >> PGDIR_SHIFT)
+#define CONSISTENT_PTE_INDEX(x) (((unsigned long)(x) - CONSISTENT_BASE) >> PMD_SHIFT)
+#define NUM_CONSISTENT_PTES (CONSISTENT_DMA_SIZE >> PMD_SHIFT)
/*
* These are the page tables (2MB each) covering uncached, DMA consistent allocations
@@ -181,7 +181,7 @@ static int __init consistent_init(void)
}
consistent_pte[i++] = pte;
- base += (1 << PGDIR_SHIFT);
+ base += (1 << PMD_SHIFT);
} while (base < CONSISTENT_END);
return ret;
diff --git a/arch/arm/mm/mmu.c b/arch/arm/mm/mmu.c
index 9d8f0c8..a69f8e4 100644
--- a/arch/arm/mm/mmu.c
+++ b/arch/arm/mm/mmu.c
@@ -865,14 +865,14 @@ static inline void prepare_page_table(void)
/*
* Clear out all the mappings below the kernel image.
*/
- for (addr = 0; addr < MODULES_VADDR; addr += PGDIR_SIZE)
+ for (addr = 0; addr < MODULES_VADDR; addr += PMD_SIZE)
pmd_clear(pmd_off_k(addr));
#ifdef CONFIG_XIP_KERNEL
/* The XIP kernel is mapped in the module area -- skip over it */
- addr = ((unsigned long)_etext + PGDIR_SIZE - 1) & PGDIR_MASK;
+ addr = ((unsigned long)_etext + PMD_SIZE - 1) & PMD_MASK;
#endif
- for ( ; addr < PAGE_OFFSET; addr += PGDIR_SIZE)
+ for ( ; addr < PAGE_OFFSET; addr += PMD_SIZE)
pmd_clear(pmd_off_k(addr));
/*
@@ -887,7 +887,7 @@ static inline void prepare_page_table(void)
* memory bank, up to the end of the vmalloc region.
*/
for (addr = __phys_to_virt(end);
- addr < VMALLOC_END; addr += PGDIR_SIZE)
+ addr < VMALLOC_END; addr += PMD_SIZE)
pmd_clear(pmd_off_k(addr));
}
@@ -928,7 +928,7 @@ static void __init devicemaps_init(struct machine_desc *mdesc)
*/
vectors_page = early_alloc(PAGE_SIZE);
- for (addr = VMALLOC_END; addr; addr += PGDIR_SIZE)
+ for (addr = VMALLOC_END; addr; addr += PMD_SIZE)
pmd_clear(pmd_off_k(addr));
/*
next prev parent reply other threads:[~2011-05-24 21:39 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-05-24 21:39 [PATCH v6 00/18] ARM: Add support for the Large Physical Address Extensions Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 01/18] ARM: LPAE: Use long long printk format for displaying the pud Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 02/18] ARM: LPAE: add ISBs around MMU enabling code Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 03/18] ARM: LPAE: Use unsigned long for __phys_to_virt and __virt_to_phys Catalin Marinas
2011-05-24 21:39 ` Catalin Marinas [this message]
2011-05-24 21:39 ` [PATCH v6 05/18] ARM: LPAE: Factor out 2-level page table definitions into separate files Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 06/18] ARM: LPAE: Add (pte|pmd|pgd|pgprot)val_t type definitions as u32 Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 07/18] ARM: LPAE: Use a mask for physical addresses in page table entries Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 08/18] ARM: LPAE: Introduce the 3-level page table format definitions Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 09/18] ARM: LPAE: Page table maintenance for the 3-level format Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 10/18] ARM: LPAE: MMU setup for the 3-level page table format Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 11/18] ARM: LPAE: Invalidate the TLB before freeing the PMD Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 12/18] ARM: LPAE: Add fault handling support Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 13/18] ARM: LPAE: Add context switching support Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 14/18] ARM: LPAE: Add identity mapping support for the 3-level page table format Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 15/18] ARM: LPAE: Use generic dma_addr_t type definition Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 16/18] ARM: LPAE: mark memory banks with start > ULONG_MAX as highmem Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 17/18] ARM: LPAE: add support for ATAG_MEM64 Catalin Marinas
2011-05-24 21:39 ` [PATCH v6 18/18] ARM: LPAE: Add the Kconfig entries Catalin Marinas
2011-05-24 23:56 ` [PATCH v6 00/18] ARM: Add support for the Large Physical Address Extensions David Brown
2011-05-25 0:44 ` Nicolas Pitre
2011-05-25 11:10 ` Arnd Bergmann
2011-05-25 11:22 ` Catalin Marinas
2011-05-25 12:43 ` Catalin Marinas
2011-05-25 8:33 ` Catalin Marinas
2011-07-01 16:24 ` Catalin Marinas
2011-07-02 12:19 ` Russell King - ARM Linux
2011-07-04 17:23 ` Catalin Marinas
2011-07-08 19:21 ` Russell King - ARM Linux
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1306273164-18217-5-git-send-email-catalin.marinas@arm.com \
--to=catalin.marinas@arm.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).