[PATCH] ARM: omap4: gpio: fix setting IRQWAKEN bits

[ccross@android.com (Colin Cross)]

Setting the IRQWAKEN bit was overwriting previous IRQWAKEN bits,
causing only the last bit set to take effect, resulting in lost
wakeups when the GPIO controller is in idle.

Replace direct writes to IRQWAKEN with writes to SETWKUENA and
CLEARWKUEN.

Signed-off-by: Colin Cross <ccross@android.com>
---
 arch/arm/plat-omap/gpio.c |   14 +++++---------
 1 files changed, 5 insertions(+), 9 deletions(-)

diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c
index c985652..23ac7b6 100644
--- a/arch/arm/plat-omap/gpio.c
+++ b/arch/arm/plat-omap/gpio.c
@@ -539,7 +539,6 @@ static inline void set_24xx_gpio_triggering(struct gpio_bank *bank, int gpio,
 {
 	void __iomem *base = bank->base;
 	u32 gpio_bit = 1 << gpio;
-	u32 val;
 
 	if (cpu_is_omap44xx()) {
 		MOD_REG_BIT(OMAP4_GPIO_LEVELDETECT0, gpio_bit,
@@ -563,14 +562,11 @@ static inline void set_24xx_gpio_triggering(struct gpio_bank *bank, int gpio,
 	if (likely(!(bank->non_wakeup_gpios & gpio_bit))) {
 		if (cpu_is_omap44xx()) {
 			if (trigger != 0)
-				__raw_writel(1 << gpio, bank->base+
-						OMAP4_GPIO_IRQWAKEN0);
-			else {
-				val = __raw_readl(bank->base +
-							OMAP4_GPIO_IRQWAKEN0);
-				__raw_writel(val & (~(1 << gpio)), bank->base +
-							 OMAP4_GPIO_IRQWAKEN0);
-			}
+				__raw_writel(gpio_bit,
+					bank->base + OMAP4_GPIO_SETWKUENA);
+			else
+				__raw_writel(gpio_bit,
+					bank->base + OMAP4_GPIO_CLEARWKUENA);
 		} else {
 			/*
 			 * GPIO wakeup request can only be generated on edge
-- 
1.7.4.1