From mboxrd@z Thu Jan 1 00:00:00 1970 From: sboyd@codeaurora.org (Stephen Boyd) Date: Tue, 20 Sep 2011 18:23:27 -0700 Subject: [PATCHv2 1/2] ARM: debug: Add UART1 config choices Message-ID: <1316568208-4518-1-git-send-email-sboyd@codeaurora.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org ARM patch 7072/1 (debug: use kconfig choice for selecting DEBUG_LL UART) didn't notice that the Kconfigs relied on being unselected to configure a different serial port. Since there is no NONE option in a choice menu, explicitly add the other option so that both serial ports can be selected. Signed-off-by: Stephen Boyd Acked-by: Will Deacon --- I plan to put these in the patch tracker if there are no further comments. arch/arm/Kconfig.debug | 19 +++++++++++++++---- 1 files changed, 15 insertions(+), 4 deletions(-) diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug index 60d1846..6dbcb00 100644 --- a/arch/arm/Kconfig.debug +++ b/arch/arm/Kconfig.debug @@ -81,14 +81,27 @@ choice prompt "Kernel low-level debugging port" depends on DEBUG_LL + + config DEBUG_FOOTBRIDGE_COM1 + bool "Kernel low-level debugging messages via footbridge 8250 at PCI COM1" + depends on FOOTBRIDGE + help + Say Y here if you want the debug print routines to direct + their output to the 8250 at PCI COM1. + config DEBUG_DC21285_PORT bool "Kernel low-level debugging messages via footbridge serial port" depends on FOOTBRIDGE help Say Y here if you want the debug print routines to direct their output to the serial port in the DC21285 (Footbridge). - Saying N will cause the debug messages to appear on the first - 16550 serial port. + + config DEBUG_CLPS711X_UART1 + bool "Kernel low-level debugging messages via UART1" + depends on ARCH_CLPS711X + help + Say Y here if you want the debug print routines to direct + their output to the first serial port on these devices. config DEBUG_CLPS711X_UART2 bool "Kernel low-level debugging messages via UART2" @@ -96,8 +109,6 @@ choice help Say Y here if you want the debug print routines to direct their output to the second serial port on these devices. - Saying N will cause the debug messages to appear on the first - serial port. endchoice -- Sent by an employee of the Qualcomm Innovation Center, Inc. The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.