[PATCH v2 2/9] gpio/omap: fix wakeup_en register update in _set_gpio_wakeup()

[tarun.kanti@ti.com (Tarun Kanti DebBarma)]

There are two ways through which wakeup_en register can be programmed
using gpiolib APIs as shown below. It is seen that in the second case
in _set_gpio_wakeup(), even though bank->suspend_wakeup is updated
correctly, its value is not programmed in wakeup_en register. Fix this.

chip.irq_set_type()->gpio_irq_type()->_set_gpio_triggering()->set_gpio_trigger()
chip.irq_set_wake()->gpio_wake_enable()->_set_gpio_wakeup()

Signed-off-by: Tarun Kanti DebBarma <tarun.kanti@ti.com>
---
 drivers/gpio/gpio-omap.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index c9369d2..895df7f 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -504,6 +504,7 @@ static int _set_gpio_wakeup(struct gpio_bank *bank, int gpio, int enable)
 	else
 		bank->suspend_wakeup &= ~gpio_bit;
 
+	__raw_writel(bank->suspend_wakeup, bank->base + bank->regs->wkup_en);
 	spin_unlock_irqrestore(&bank->lock, flags);
 
 	return 0;
-- 
1.7.0.4