From mboxrd@z Thu Jan 1 00:00:00 1970 From: stigge@antcom.de (Roland Stigge) Date: Sat, 21 Apr 2012 11:34:23 +0200 Subject: [PATCH v5 5/10] ARM: LPC32xx: Remove obsolete platform Kconfig In-Reply-To: <1335000868-21974-1-git-send-email-stigge@antcom.de> References: <1335000868-21974-1-git-send-email-stigge@antcom.de> Message-ID: <1335000868-21974-6-git-send-email-stigge@antcom.de> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch removes two Kconfig options now unused (the network driver is configured via DT now). Signed-off-by: Roland Stigge --- Applies to v3.4-rc3 --- linux-2.6.orig/arch/arm/mach-lpc32xx/Kconfig +++ linux-2.6/arch/arm/mach-lpc32xx/Kconfig @@ -29,30 +29,4 @@ config ARCH_LPC32XX_UART6_SELECT endmenu -menu "LPC32XX chip components" - -config ARCH_LPC32XX_IRAM_FOR_NET - bool "Use IRAM for network buffers" - default y - help - Say Y here to use the LPC internal fast IRAM (i.e. 256KB SRAM) as - network buffer. If the total combined required buffer sizes is - larger than the size of IRAM, then SDRAM will be used instead. - - This can be enabled safely if the IRAM is not intended for other - uses. - -config ARCH_LPC32XX_MII_SUPPORT - bool "Check to enable MII support or leave disabled for RMII support" - help - Say Y here to enable MII support, or N for RMII support. Regardless of - which support is selected, the ethernet interface driver needs to be - selected in the device driver networking section. - - The PHY3250 reference board uses RMII, so users of this board should - say N. - -endmenu - endif -