[PATCH v2 1/5] net: fec: reset phy after pinctrl setup

[shawn.guo@linaro.org (Shawn Guo)]

In case that bootloader or platform initialization does not set up
fec pins, the fec_reset_phy will not be able to succeed, because
fec_reset_phy is currently called before devm_pinctrl_get_select_default.
Move fec_reset_phy call to the place between devm_pinctrl_get_select_default
and fec_enet_init to have above case be taken care.

Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
---
 drivers/net/ethernet/freescale/fec.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/freescale/fec.c b/drivers/net/ethernet/freescale/fec.c
index ff7f4c5..e868a37 100644
--- a/drivers/net/ethernet/freescale/fec.c
+++ b/drivers/net/ethernet/freescale/fec.c
@@ -1593,8 +1593,6 @@ fec_probe(struct platform_device *pdev)
 		fep->phy_interface = ret;
 	}
 
-	fec_reset_phy(pdev);
-
 	for (i = 0; i < FEC_IRQ_NUM; i++) {
 		irq = platform_get_irq(pdev, i);
 		if (irq < 0) {
@@ -1634,6 +1632,8 @@ fec_probe(struct platform_device *pdev)
 	clk_prepare_enable(fep->clk_ahb);
 	clk_prepare_enable(fep->clk_ipg);
 
+	fec_reset_phy(pdev);
+
 	ret = fec_enet_init(ndev);
 	if (ret)
 		goto failed_init;
-- 
1.7.5.4