linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: cyril@ti.com (Cyril Chemparathy)
To: linux-arm-kernel@lists.infradead.org
Subject: [RFC 12/23] ARM: mm: clean up membank size limit checks
Date: Tue, 24 Jul 2012 01:10:18 -0000	[thread overview]
Message-ID: <1343092165-9470-13-git-send-email-cyril@ti.com> (raw)
In-Reply-To: <1343092165-9470-1-git-send-email-cyril@ti.com>

This patch cleans up the highmem sanity check code by simplifying the range
checks with a pre-calculated size_limit.  This patch should otherwise have no
functional impact on behavior.

This patch also removes a redundant (bank->start < vmalloc_limit) check, since
this is already covered by the !highmem condition.

Signed-off-by: Cyril Chemparathy <cyril@ti.com>
Signed-off-by: Vitaly Andrianov <vitalya@ti.com>
---
 arch/arm/mm/mmu.c |   19 +++++++++++--------
 1 file changed, 11 insertions(+), 8 deletions(-)

diff --git a/arch/arm/mm/mmu.c b/arch/arm/mm/mmu.c
index 4840efa..6b0baf3 100644
--- a/arch/arm/mm/mmu.c
+++ b/arch/arm/mm/mmu.c
@@ -905,10 +905,15 @@ void __init sanity_check_meminfo(void)
 
 	for (i = 0, j = 0; i < meminfo.nr_banks; i++) {
 		struct membank *bank = &meminfo.bank[j];
+		phys_addr_t size_limit;
+
 		*bank = meminfo.bank[i];
+		size_limit = bank->size;
 
 		if (bank->start >= vmalloc_limit)
 			highmem = 1;
+		else
+			size_limit = vmalloc_limit - bank->start;
 
 		bank->highmem = highmem;
 
@@ -917,8 +922,7 @@ void __init sanity_check_meminfo(void)
 		 * Split those memory banks which are partially overlapping
 		 * the vmalloc area greatly simplifying things later.
 		 */
-		if (!highmem && bank->start < vmalloc_limit &&
-		    bank->size > vmalloc_limit - bank->start) {
+		if (!highmem && bank->size > size_limit) {
 			if (meminfo.nr_banks >= NR_BANKS) {
 				printk(KERN_CRIT "NR_BANKS too low, "
 						 "ignoring high memory\n");
@@ -927,12 +931,12 @@ void __init sanity_check_meminfo(void)
 					(meminfo.nr_banks - i) * sizeof(*bank));
 				meminfo.nr_banks++;
 				i++;
-				bank[1].size -= vmalloc_limit - bank->start;
+				bank[1].size -= size_limit;
 				bank[1].start = vmalloc_limit;
 				bank[1].highmem = highmem = 1;
 				j++;
 			}
-			bank->size = vmalloc_limit - bank->start;
+			bank->size = size_limit;
 		}
 #else
 		/*
@@ -950,14 +954,13 @@ void __init sanity_check_meminfo(void)
 		 * Check whether this memory bank would partially overlap
 		 * the vmalloc area.
 		 */
-		if (bank->start + bank->size > vmalloc_limit)
-			unsigned long newsize = vmalloc_limit - bank->start;
+		if (bank->size > size_limit) {
 			printk(KERN_NOTICE "Truncating RAM at %.8llx-%.8llx "
 			       "to -%.8llx (vmalloc region overlap).\n",
 			       (unsigned long long)bank->start,
 			       (unsigned long long)bank->start + bank->size - 1,
-			       (unsigned long long)bank->start + newsize - 1);
-			bank->size = newsize;
+			       (unsigned long long)bank->start + size_limit - 1);
+			bank->size = size_limit;
 		}
 #endif
 		if (!bank->highmem && bank->start + bank->size > arm_lowmem_limit)
-- 
1.7.9.5

  parent reply	other threads:[~2012-07-24  1:10 UTC|newest]

Thread overview: 44+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2012-07-24  1:09 [RFC 00/23] Introducing the TI Keystone platform Cyril Chemparathy
2012-07-24  1:09 ` [RFC 01/23] ARM: LPAE: disable phys-to-virt patching on PAE systems Cyril Chemparathy
2012-07-24  9:41   ` Catalin Marinas
2012-07-24 10:43     ` Cyril Chemparathy
2012-07-24  1:09 ` [RFC 02/23] ARM: LPAE: use signed arithmetic for mask definitions Cyril Chemparathy
2012-07-24 10:05   ` Catalin Marinas
2012-07-24 10:52     ` Cyril Chemparathy
2012-07-31 15:35     ` Cyril Chemparathy
2012-07-24  1:09 ` [RFC 05/23] ARM: LPAE: use phys_addr_t in free_memmap() Cyril Chemparathy
2012-07-24  1:10 ` [RFC 04/23] ARM: LPAE: use phys_addr_t in alloc_init_pud() Cyril Chemparathy
2012-07-24  1:10 ` [RFC 08/23] ARM: LPAE: use 64-bit pgd physical address in switch_mm() Cyril Chemparathy
2012-07-24  1:10 ` [RFC 16/23] ARM: LPAE: accomodate >32-bit addresses for page table base Cyril Chemparathy
2012-07-24  1:10 ` [RFC 07/23] ARM: LPAE: use phys_addr_t for membank size Cyril Chemparathy
2012-07-24 10:04   ` Will Deacon
2012-07-24 10:46     ` Cyril Chemparathy
2012-07-24  1:10 ` [RFC 11/23] ARM: mm: cleanup checks for membank overlap with vmalloc area Cyril Chemparathy
2012-07-24  1:10 ` [RFC 20/23] mm: bootmem: use phys_addr_t for physical addresses Cyril Chemparathy
2012-07-24  1:10 ` Cyril Chemparathy [this message]
2012-07-24  1:10 ` [RFC 17/23] ARM: add machine desc hook for early memory/paging initialization Cyril Chemparathy
2012-07-24 14:32   ` Arnd Bergmann
2012-07-24 14:47     ` Cyril Chemparathy
2012-07-24  1:10 ` [RFC 03/23] ARM: LPAE: use phys_addr_t on virt <--> phys conversion Cyril Chemparathy
2012-07-24 10:37   ` Catalin Marinas
2012-07-24 10:55     ` Cyril Chemparathy
2012-07-24 11:02       ` Catalin Marinas
2012-07-24  1:10 ` [RFC 09/23] ARM: LPAE: use 64-bit accessors for TTBR registers Cyril Chemparathy
2012-07-24  1:10 ` [RFC 18/23] ARM: add virt_to_idmap for interconnect aliasing Cyril Chemparathy
2012-07-24  1:10 ` [RFC 13/23] ARM: LPAE: define ARCH_LOW_ADDRESS_LIMIT for bootmem Cyril Chemparathy
2012-07-24  1:10 ` [RFC 10/23] ARM: mm: use physical addresses in highmem sanity checks Cyril Chemparathy
2012-07-24  1:10 ` [RFC 15/23] ARM: LPAE: allow proc override of TTB setup Cyril Chemparathy
2012-07-24  1:10 ` [RFC 22/23] ARM: keystone: enable SMP on Keystone machines Cyril Chemparathy
2012-07-24  1:33 ` [RFC 23/23] ARM: keystone: add switch over to high physical address range Cyril Chemparathy
2012-07-24  9:49   ` Catalin Marinas
2012-07-24 14:39   ` Arnd Bergmann
2012-07-24 14:59     ` Cyril Chemparathy
2012-07-24  1:33 ` [RFC 06/23] ARM: LPAE: use phys_addr_t for initrd location and size Cyril Chemparathy
2012-07-24  1:38 ` [RFC 19/23] drivers: cma: fix addressing on PAE machines Cyril Chemparathy
2012-07-24  1:38 ` [RFC 21/23] ARM: keystone: introducing TI Keystone platform Cyril Chemparathy
2012-07-24 14:46   ` Arnd Bergmann
2012-07-24 17:56     ` Cyril Chemparathy
2012-07-24 18:45       ` Arnd Bergmann
2012-07-24  1:38 ` [RFC 14/23] ARM: LPAE: factor out T1SZ and TTBR1 computations Cyril Chemparathy
2012-07-24  9:08 ` [RFC 00/23] Introducing the TI Keystone platform Will Deacon
2012-07-24 10:41   ` Cyril Chemparathy

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1343092165-9470-13-git-send-email-cyril@ti.com \
    --to=cyril@ti.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).