From: ian.molton@codethink.co.uk (Ian Molton)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 5/6] csb1724: Enable device tree based mv643xx ethernet support.
Date: Mon, 30 Jul 2012 16:15:58 +0100 [thread overview]
Message-ID: <1343661359-10150-6-git-send-email-ian.molton@codethink.co.uk> (raw)
In-Reply-To: <1343661359-10150-1-git-send-email-ian.molton@codethink.co.uk>
This patch enables mv643xx based ethernet built into the SoM on the
csb1724, via flattened device tree.
Signed-off-by: Ian Molton <ian.molton@codethink.co.uk>
---
arch/arm/boot/dts/kirkwood-csb1724.dts | 25 ++++++++++++++++++
arch/arm/boot/dts/kirkwood.dtsi | 16 ++++++++++++
arch/arm/configs/csb1724_defconfig | 45 ++++++++++++++++++++++++++++++++
arch/arm/mach-kirkwood/board-csb1724.c | 3 +++
4 files changed, 89 insertions(+)
diff --git a/arch/arm/boot/dts/kirkwood-csb1724.dts b/arch/arm/boot/dts/kirkwood-csb1724.dts
index 44dfe9a..f652797 100644
--- a/arch/arm/boot/dts/kirkwood-csb1724.dts
+++ b/arch/arm/boot/dts/kirkwood-csb1724.dts
@@ -25,6 +25,31 @@
nr-ports = <2>;
status = "ok";
};
+
+ smi0: mdio at 72000 {
+ status = "ok";
+ };
+
+ smi1: mdio at 76000 {
+ status = "ok";
+ };
+
+ egiga0 {
+ compatible = "marvell,mv643xx";
+ mdio = <&smi0>;
+ port_number = <0>;
+ phy_addr = <0x80>;
+ interrupts = <11>;
+ };
+
+ egiga1 {
+ compatible = "marvell,mv643xx";
+ mdio = <&smi1>;
+ port_number = <0>;
+ phy_addr = <0x81>;
+ interrupts = <15>;
+ };
+
};
};
diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi
index cef9616..dd10422 100644
--- a/arch/arm/boot/dts/kirkwood.dtsi
+++ b/arch/arm/boot/dts/kirkwood.dtsi
@@ -105,5 +105,21 @@
clock-frequency = <100000>;
status = "disabled";
};
+
+ smi0: mdio at 72000 {
+ compatible = "marvell,mdio-mv643xx";
+ reg = <0x72000 0x4000>;
+ interrupts = <46>;
+ status = "disabled";
+ };
+
+ smi1: mdio at 76000 {
+ compatible = "marvell,mdio-mv643xx";
+ reg = <0x76000 0x4000>;
+ interrupts = <47>;
+ shared_smi = <&smi0>;
+ status = "disabled";
+ };
+
};
};
diff --git a/arch/arm/configs/csb1724_defconfig b/arch/arm/configs/csb1724_defconfig
index 927b269..fbea657 100644
--- a/arch/arm/configs/csb1724_defconfig
+++ b/arch/arm/configs/csb1724_defconfig
@@ -45,3 +45,48 @@ CONFIG_PROC_DEVICETREE=y
CONFIG_BLK_DEV_LOOP=y
CONFIG_BLK_DEV_LOOP_MIN_COUNT=8
CONFIG_DYNAMIC_DEBUG=y
+CONFIG_NET=y
+CONFIG_INET=y
+CONFIG_NETDEVICES=y
+CONFIG_MV643XX_ETH=y
+CONFIG_PACKET=y
+CONFIG_UNIX=y
+CONFIG_IPV6=n
+CONFIG_NET_VENDOR_3COM=n
+CONFIG_NET_VENDOR_ADAPTEC=n
+CONFIG_NET_VENDOR_ALTEON=n
+CONFIG_NET_VENDOR_AMD=n
+CONFIG_NET_VENDOR_ATHEROS=n
+CONFIG_NET_VENDOR_BROADCOM=n
+CONFIG_NET_VENDOR_BROCADE=n
+CONFIG_NET_VENDOR_CHELSIO=n
+CONFIG_NET_VENDOR_CIRRUS=n
+CONFIG_NET_VENDOR_CISCO=n
+CONFIG_NET_VENDOR_DEC=n
+CONFIG_NET_VENDOR_HP=n
+CONFIG_NET_VENDOR_DLINK=n
+CONFIG_NET_VENDOR_EMULEX=n
+CONFIG_NET_VENDOR_EXAR=n
+CONFIG_NET_VENDOR_FARADAY=n
+CONFIG_NET_VENDOR_INTEL=n
+CONFIG_NET_VENDOR_MELLANOX=n
+CONFIG_NET_VENDOR_MICREL=n
+CONFIG_NET_VENDOR_MYRI=n
+CONFIG_NET_VENDOR_NATSEMI=n
+CONFIG_NET_VENDOR_NVIDIA=n
+CONFIG_NET_VENDOR_OKI=n
+CONFIG_NET_PACKET_ENGINE=n
+CONFIG_NET_VENDOR_QLOGIC=n
+CONFIG_NET_VENDOR_REALTEK=n
+CONFIG_NET_VENDOR_RDC=n
+CONFIG_NET_VENDOR_SEEQ=n
+CONFIG_NET_VENDOR_SILAN=n
+CONFIG_NET_VENDOR_SIS=n
+CONFIG_NET_VENDOR_SMSC=n
+CONFIG_NET_VENDOR_STMICRO=n
+CONFIG_NET_VENDOR_SUN=n
+CONFIG_NET_VENDOR_TEHUTI=n
+CONFIG_NET_VENDOR_TI=n
+CONFIG_NET_VENDOR_VIA=n
+CONFIG_NET_VENDOR_WIZNET=n
+
diff --git a/arch/arm/mach-kirkwood/board-csb1724.c b/arch/arm/mach-kirkwood/board-csb1724.c
index 979112d..50f0c5b 100644
--- a/arch/arm/mach-kirkwood/board-csb1724.c
+++ b/arch/arm/mach-kirkwood/board-csb1724.c
@@ -13,6 +13,7 @@
#include <linux/kernel.h>
#include <linux/init.h>
+#include "common.h"
#include "mpp.h"
static unsigned int csb1724_mpp_config[] __initdata = {
@@ -56,4 +57,6 @@ void __init csb1724_init(void)
* Basic setup. Needs to be called early.
*/
kirkwood_mpp_conf(csb1724_mpp_config);
+ kirkwood_ge00_init(NULL);
+ kirkwood_ge01_init(NULL);
}
--
1.7.9.5
next prev parent reply other threads:[~2012-07-30 15:15 UTC|newest]
Thread overview: 35+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-07-30 15:15 [PATCH 0/6] mv643xx Ethernet DT support and CSB1724 board support Ian Molton
2012-07-30 15:15 ` [PATCH 1/6] Initial csb1724 board support (FDT) Ian Molton
2012-07-30 15:28 ` Andrew Lunn
2012-07-30 16:28 ` Ian Molton
2012-07-31 11:27 ` Arnd Bergmann
2012-07-30 15:15 ` [PATCH 2/6] mv643xx.c: Remove magic numbers Ian Molton
2012-07-30 15:15 ` [PATCH 3/6] mv643xx.c: Add basic device tree support Ian Molton
2012-07-30 15:39 ` Andrew Lunn
2012-07-30 16:49 ` Ian Molton
2012-07-30 16:19 ` Amar Nath
2012-07-30 16:32 ` Ian Molton
2012-07-31 15:12 ` Florian Fainelli
2012-07-31 7:14 ` Arnaud Patard (Rtp)
2012-07-31 8:19 ` Ian Molton
2012-07-31 8:27 ` Andrew Lunn
2012-07-31 8:45 ` Ian Molton
2012-07-31 8:58 ` Arnaud Patard (Rtp)
2012-07-31 9:14 ` Ian Molton
2012-07-31 14:30 ` Ben Dooks
2012-07-31 15:04 ` Arnaud Patard (Rtp)
2012-07-30 15:15 ` [PATCH 4/6] kirkwood: setup clock only in eth helpers Ian Molton
2012-07-30 16:12 ` Andrew Lunn
2012-07-30 16:52 ` Ian Molton
2012-07-30 19:10 ` Andrew Lunn
2012-07-30 16:46 ` Josh Coombs
2012-07-31 8:23 ` Ian Molton
2012-07-31 11:04 ` Ian Molton
2012-07-31 11:08 ` Andrew Lunn
2012-07-31 11:39 ` Ian Molton
2012-07-30 15:15 ` Ian Molton [this message]
2012-07-30 15:55 ` [PATCH 5/6] csb1724: Enable device tree based mv643xx ethernet support Andrew Lunn
2012-07-30 16:58 ` Ian Molton
2012-07-30 16:17 ` Andrew Lunn
2012-07-30 16:57 ` Ian Molton
2012-07-30 15:15 ` [PATCH 6/6] DT: Convert all kirkwood boards with mv643xx that use DT Ian Molton
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1343661359-10150-6-git-send-email-ian.molton@codethink.co.uk \
--to=ian.molton@codethink.co.uk \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).