From: stigge@antcom.de (Roland Stigge)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH RFC 4/6 v3] gpio-max730x: Add block GPIO API
Date: Fri, 12 Oct 2012 21:11:23 +0200 [thread overview]
Message-ID: <1350069085-13283-5-git-send-email-stigge@antcom.de> (raw)
In-Reply-To: <1350069085-13283-1-git-send-email-stigge@antcom.de>
This patch adds block GPIO API support to the MAX730x driver.
Due to hardware constraints in this chip, simultaneous access to GPIO lines can
only be done in groups of 8: GPIOs 0-7, 8-15, 16-23, 24-27. However, setting
and clearing will be done at once.
Signed-off-by: Roland Stigge <stigge@antcom.de>
---
drivers/gpio/gpio-max730x.c | 60 ++++++++++++++++++++++++++++++++++++++++++++
1 file changed, 60 insertions(+)
--- linux-2.6.orig/drivers/gpio/gpio-max730x.c
+++ linux-2.6/drivers/gpio/gpio-max730x.c
@@ -146,6 +146,43 @@ static int max7301_get(struct gpio_chip
return level;
}
+static unsigned max7301_get_block(struct gpio_chip *chip, unsigned mask)
+{
+ struct max7301 *ts = container_of(chip, struct max7301, chip);
+ int i, j;
+ unsigned result = 0;
+
+ for (i = 0; i < 4; i++) {
+ if ((mask >> (i * 8)) & 0xFF) { /* i/o only if necessary */
+ u8 in_level = ts->read(ts->dev, 0x44 + i * 8);
+ u8 in_mask = 0;
+ u8 out_level = (ts->out_level >> (i * 8 + 4)) & 0xFF;
+ u8 out_mask = 0;
+
+ for (j = 0; j < 8; j++) {
+ int offset = 4 + i * 8 + j;
+ int config = (ts->port_config[offset >> 2] >>
+ ((offset & 3) << 1)) &
+ PIN_CONFIG_MASK;
+
+ switch (config) {
+ case PIN_CONFIG_OUT:
+ out_mask |= BIT(j);
+ break;
+ case PIN_CONFIG_IN_WO_PULLUP:
+ case PIN_CONFIG_IN_PULLUP:
+ in_mask |= BIT(j);
+ }
+ }
+
+ result |= ((unsigned)(in_level & in_mask) |
+ (out_level & out_mask)) << (i * 8);
+ }
+ }
+
+ return result & mask;
+}
+
static void max7301_set(struct gpio_chip *chip, unsigned offset, int value)
{
struct max7301 *ts = container_of(chip, struct max7301, chip);
@@ -160,6 +197,27 @@ static void max7301_set(struct gpio_chip
mutex_unlock(&ts->lock);
}
+static
+void max7301_set_block(struct gpio_chip *chip, unsigned mask, unsigned values)
+{
+ struct max7301 *ts = container_of(chip, struct max7301, chip);
+ unsigned changes;
+ int i;
+
+ mutex_lock(&ts->lock);
+
+ changes = (ts->out_level ^ (values << 4)) & (mask << 4);
+ ts->out_level ^= changes;
+
+ for (i = 0; i < 4; i++) {
+ if ((changes >> (i * 8 + 4)) & 0xFF) /* i/o only on change */
+ ts->write(ts->dev, 0x44 + i * 8,
+ (ts->out_level >> (i * 8 + 4)) & 0xFF);
+ }
+
+ mutex_unlock(&ts->lock);
+}
+
int __devinit __max730x_probe(struct max7301 *ts)
{
struct device *dev = ts->dev;
@@ -183,8 +241,10 @@ int __devinit __max730x_probe(struct max
ts->chip.direction_input = max7301_direction_input;
ts->chip.get = max7301_get;
+ ts->chip.get_block = max7301_get_block;
ts->chip.direction_output = max7301_direction_output;
ts->chip.set = max7301_set;
+ ts->chip.set_block = max7301_set_block;
ts->chip.base = pdata->base;
ts->chip.ngpio = PIN_NUMBER;
next prev parent reply other threads:[~2012-10-12 19:11 UTC|newest]
Thread overview: 22+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-10-12 19:11 [PATCH RFC 0/6 v3] gpio: Add block GPIO Roland Stigge
2012-10-12 19:11 ` [PATCH RFC 1/6 v3] gpio: Add a block GPIO API to gpiolib Roland Stigge
2012-10-15 5:20 ` Ryan Mallon
2012-10-15 17:20 ` Roland Stigge
2012-10-15 22:05 ` Ryan Mallon
2012-10-15 22:55 ` Roland Stigge
2012-10-15 19:56 ` Linus Walleij
2012-10-12 19:11 ` [PATCH RFC 2/6 v3] gpio: Add sysfs support to block GPIO API Roland Stigge
2012-10-15 5:35 ` Ryan Mallon
2012-10-15 18:01 ` Roland Stigge
2012-10-15 18:07 ` Jean-Christophe PLAGNIOL-VILLARD
2012-10-15 18:15 ` Roland Stigge
2012-10-15 18:19 ` Greg Kroah-Hartman
2012-10-15 20:30 ` Linus Walleij
2012-10-15 21:38 ` Roland Stigge
2012-10-16 8:43 ` Jean-Christophe PLAGNIOL-VILLARD
2012-10-18 4:38 ` Daniel Glöckner
2012-10-19 10:29 ` Linus Walleij
2012-10-12 19:11 ` [PATCH RFC 3/6 v3] gpio: Add device tree " Roland Stigge
2012-10-12 19:11 ` Roland Stigge [this message]
2012-10-12 19:11 ` [PATCH RFC 5/6 v3] gpio-lpc32xx: Add " Roland Stigge
2012-10-12 19:11 ` [PATCH RFC 6/6 v3] gpio-generic: " Roland Stigge
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1350069085-13283-5-git-send-email-stigge@antcom.de \
--to=stigge@antcom.de \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).