From mboxrd@z Thu Jan 1 00:00:00 1970 From: shawn.guo@linaro.org (Shawn Guo) Date: Mon, 15 Oct 2012 16:48:04 +0800 Subject: [PATCH] ARM: dts: imx6q-arm2: move NANDF_CS pins out of 'hog' Message-ID: <1350290884-26594-1-git-send-email-shawn.guo@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Commit 9e3c0066 (ARM: dts: imx6q-arm2: add pinctrl for uart and enet) defines NANDF_CS pins as gpio in 'hog', assuming these two pins are always used by usdhc3 in gpio mode as card-detection and write-protection on ARM2 board. But it's not true. These pins are shared by usdhc3 and gpmi-nand. We should have the pins functional for gpmi-nand when usdhc3 is disabled. Move the pins out of 'hog', so that pins only work in gpio mode as CD and WP when usdhc3 is enabled, and otherwise they are available for gpmi-nand. Reported-by: Huang Shijie Signed-off-by: Shawn Guo --- Huang, Please help test the patch to see if it fixes your problem, thanks. Shawn arch/arm/boot/dts/imx6q-arm2.dts | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/imx6q-arm2.dts b/arch/arm/boot/dts/imx6q-arm2.dts index 15df4c1..5bfa02a 100644 --- a/arch/arm/boot/dts/imx6q-arm2.dts +++ b/arch/arm/boot/dts/imx6q-arm2.dts @@ -37,6 +37,13 @@ pinctrl_hog: hoggrp { fsl,pins = < 176 0x80000000 /* MX6Q_PAD_EIM_D25__GPIO_3_25 */ + >; + }; + }; + + arm2 { + pinctrl_usdhc3_arm2: usdhc3grp-arm2 { + fsl,pins = < 1363 0x80000000 /* MX6Q_PAD_NANDF_CS0__GPIO_6_11 */ 1369 0x80000000 /* MX6Q_PAD_NANDF_CS1__GPIO_6_14 */ >; @@ -58,7 +65,8 @@ wp-gpios = <&gpio6 14 0>; vmmc-supply = <®_3p3v>; pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_usdhc3_1>; + pinctrl-0 = <&pinctrl_usdhc3_1 + &pinctrl_usdhc3_arm2>; status = "okay"; }; -- 1.7.9.5