From mboxrd@z Thu Jan 1 00:00:00 1970 From: andrew@lunn.ch (Andrew Lunn) Date: Sat, 20 Oct 2012 15:11:24 -0000 Subject: [RFC 07/11] ARM: Kirkwood: Convert dreamplug to pinctrl. In-Reply-To: <1350745663-5277-1-git-send-email-andrew@lunn.ch> References: <1350745663-5277-1-git-send-email-andrew@lunn.ch> Message-ID: <1350745663-5277-8-git-send-email-andrew@lunn.ch> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Signed-off-by: Andrew Lunn --- arch/arm/boot/dts/kirkwood-dreamplug.dts | 26 ++++++++++++++++++++++++++ arch/arm/mach-kirkwood/board-dreamplug.c | 14 -------------- 2 files changed, 26 insertions(+), 14 deletions(-) diff --git a/arch/arm/boot/dts/kirkwood-dreamplug.dts b/arch/arm/boot/dts/kirkwood-dreamplug.dts index 26e281f..4d1ef46 100644 --- a/arch/arm/boot/dts/kirkwood-dreamplug.dts +++ b/arch/arm/boot/dts/kirkwood-dreamplug.dts @@ -16,6 +16,32 @@ }; ocp at f1000000 { + pinctrl: pinctrl at 10000 { + compatible = "marvell,88f6281-pinctrl"; + reg = <0x10000 0x20>; + + pinctrl-0 = < &pmx_spi + &pmx_led_bluetooth &pmx_led_wifi + &pmx_led_wifi_ap >; + pinctrl-names = "default"; + + pmx_spi: pmx-spi { + marvell,pins = "mpp0", "mpp1", "mpp2", "mpp3"; + marvell,function = "spi"; + }; + pmx_led_bluetooth: pmx-led-bluetooth { + marvell,pins = "mpp47"; + marvell,function = "gpio"; + }; + pmx_led_wifi: pmx-led-wifi { + marvell,pins = "mpp48"; + marvell,function = "gpio"; + }; + pmx_led_wifi_ap: pmx-led-wifi-ap { + marvell,pins = "mpp49"; + marvell,function = "gpio"; + }; + }; serial at 12000 { clock-frequency = <200000000>; status = "ok"; diff --git a/arch/arm/mach-kirkwood/board-dreamplug.c b/arch/arm/mach-kirkwood/board-dreamplug.c index 20af53a..db0c280 100644 --- a/arch/arm/mach-kirkwood/board-dreamplug.c +++ b/arch/arm/mach-kirkwood/board-dreamplug.c @@ -32,7 +32,6 @@ #include #include #include "common.h" -#include "mpp.h" static struct mv643xx_eth_platform_data dreamplug_ge00_data = { .phy_addr = MV643XX_ETH_PHY_ADDR(0), @@ -46,24 +45,11 @@ static struct mvsdio_platform_data dreamplug_mvsdio_data = { /* unfortunately the CD signal has not been connected */ }; -static unsigned int dreamplug_mpp_config[] __initdata = { - MPP0_SPI_SCn, - MPP1_SPI_MOSI, - MPP2_SPI_SCK, - MPP3_SPI_MISO, - MPP47_GPIO, /* Bluetooth LED */ - MPP48_GPIO, /* Wifi LED */ - MPP49_GPIO, /* Wifi AP LED */ - 0 -}; - void __init dreamplug_init(void) { /* * Basic setup. Needs to be called early. */ - kirkwood_mpp_conf(dreamplug_mpp_config); - kirkwood_ehci_init(); kirkwood_ge00_init(&dreamplug_ge00_data); kirkwood_ge01_init(&dreamplug_ge01_data); -- 1.7.10.4