[PATCH v4 0/9] use pinctrl-single in arch mmp

[haojian.zhuang@gmail.com (Haojian Zhuang)]

Changelog:
v4:
1. Define gpio range as sub-node, not label. And remove
pinctrl-single,gpio-ranges property.
2. Use new two properties in sub-node, reg &
pinctrl-single,gpio. GPIO number & GPIO function are listed in
the pinctrl-single,gpio property.
3. Reference the names like pinctrl-single,bias.
4. Add compatible name "pinconf-single". If the compatible name is
"pinctrl-single", there's no pinconf. If the compatible name is
"pinconf-single", there's the generic pinconf in pinctrl-single.
5. Update documents.

v3:
1. Add more comments in document.
2. Replace pcs_readl() & pcs_writel() by pcs->read() & pcs->write().
3. Clean code.

v2:
1. Remove "pinctrl-single,gpio-mask". Since GPIO function is one of the
mux function in the pinmux register of both OMAP and PXA/MMP silicons.
Use "pinctrl-single,function-mask" instead.
2. Remove "pinctrl-single,gpio-enable" & "pinctrl-single,gpio-disable".
Use "pinctrl-single,gpio-func" instead. Because GPIO mode is only one
of the mux functions in the pinmux register. Defining "gpio-enable" &
"gpio-disable" are redundant.
3. Define register with __iomem, not u32 type.
4. Remove "pinctrl-single,input-schmit-shift",
"pinctrl-single,power-source-shift", "pinctrl-single,bias-shift". All
these properties could be calculated by mask fields.
5. Return -EPROBE_DEFER if pinmux could be got in device driver. And
the device driver would be probed again deferred.