From mboxrd@z Thu Jan 1 00:00:00 1970 From: lee.jones@linaro.org (Lee Jones) Date: Wed, 9 Jan 2013 10:06:05 +0000 Subject: [PATCH 3/3] ARM: ux500: Add Snowball pin configuration for user LED In-Reply-To: <1357725965-27342-1-git-send-email-lee.jones@linaro.org> References: <1357725965-27342-1-git-send-email-lee.jones@linaro.org> Message-ID: <1357725965-27342-3-git-send-email-lee.jones@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Here we setup the GPIO pin responsible for illuminating the user LED on the Snowball low-cost development board. Signed-off-by: Lee Jones --- arch/arm/mach-ux500/board-mop500-pins.c | 2 ++ 1 file changed, 2 insertions(+) diff --git a/arch/arm/mach-ux500/board-mop500-pins.c b/arch/arm/mach-ux500/board-mop500-pins.c index 0a3f30d..d1a775c 100644 --- a/arch/arm/mach-ux500/board-mop500-pins.c +++ b/arch/arm/mach-ux500/board-mop500-pins.c @@ -747,6 +747,8 @@ static struct pinctrl_map __initdata snowball_pinmap[] = { DB8500_PIN_HOG("GPIO21_AB3", out_hi), /* Mux in "SM" which is used for the SMSC911x Ethernet adapter */ DB8500_MUX_HOG("sm_b_1", "sm"), + /* User LED */ + DB8500_PIN_HOG("GPIO142_C11", gpio_out_hi), /* Drive RSTn_LAN high */ DB8500_PIN_HOG("GPIO141_C12", gpio_out_hi), /* Accelerometer/Magnetometer */ -- 1.7.9.5