[PATCH v3 1/1 net-next] net: fec: enable pause frame to improve rx prefomance for 1G network

[bhutchings@solarflare.com (Ben Hutchings)]

On Fri, 2013-01-25 at 09:50 +0800, Frank Li wrote:
> 2013/1/25 Ben Hutchings <bhutchings@solarflare.com>:
> > On Thu, 2013-01-24 at 10:16 +0800, Frank Li wrote:
> >> 2013/1/24 Ben Hutchings <bhutchings@solarflare.com>:
> >> > On Thu, 2013-01-17 at 10:55 +0800, Frank Li wrote:
> >> >> The limition of imx6 internal bus cause fec can't achieve 1G perfomance.
> >> >> There will be many packages lost because FIFO over run.
> >> >>
> >> >> This patch enable pause frame flow control.
> >> > [...]
> >> >> --- a/drivers/net/ethernet/freescale/fec.c
> >> >> +++ b/drivers/net/ethernet/freescale/fec.c
> >> > [...]
> >> >> +static int fec_enet_set_pauseparam(struct net_device *ndev,
> >> >> +                                struct ethtool_pauseparam *pause)
> >> >> +{
> >> >> +     struct fec_enet_private *fep = netdev_priv(ndev);
> >> >> +
> >> >> +     if (pause->tx_pause != pause->rx_pause) {
> >> >> +             netdev_info(ndev,
> >> >> +                     "hardware only support enable/disable both tx and rx");
> >> >> +             return -EINVAL;
> >> >> +     }
> >> >> +
> >> >> +     fep->pause_flag = 0;
> >> >> +
> >> >> +     /* tx pause must be same as rx pause */
> >> >> +     fep->pause_flag |= pause->rx_pause ? FEC_PAUSE_FLAG_ENABLE : 0;
> >> >> +     fep->pause_flag |= pause->autoneg ? FEC_PAUSE_FLAG_AUTONEG : 0;
> >> >> +
> >> >> +     if (pause->rx_pause || pause->autoneg) {
> >> >> +             fep->phy_dev->supported |= ADVERTISED_Pause;
> >> >> +             fep->phy_dev->advertising |= ADVERTISED_Pause;
> >> >> +     } else {
> >> >> +             fep->phy_dev->supported &= ~ADVERTISED_Pause;
> >> >> +             fep->phy_dev->advertising &= ~ADVERTISED_Pause;
> >> >> +     }
> >> > [...]
> >> >
> >> > Why is this changing the supported flags, i.e. device capabilities?  You
> >> > need to leave those flags alone and reject an attempt to enable pause
> >> > frames on a device that doesn't support them.
> >>
> >> I go through phylib, I have not found good place set ADVERTISED_Pause
> >> capabilities.
> >> genphy_config_init never check Pause capabilities.
> >
> > I agree that phylib can't initialise pause capabilities because those
> > depend on the MAC.  But look at which function I'm quoting: this is the
> > ethtool operation, which shouldn't change capabilities.
> 
> Where is good place do you think? in probe function?

You're already setting the supported flag in fec_enet_mii_probe().  I
assume (without great familiarity with phylib) that that's the right
place to do it.

Ben.

-- 
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.