From: lee.jones@linaro.org (Lee Jones)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 02/40] pm2301-charger: Enable SW EOC control on the ab9540
Date: Fri, 15 Feb 2013 12:44:32 +0000 [thread overview]
Message-ID: <1360932310-30065-3-git-send-email-lee.jones@linaro.org> (raw)
In-Reply-To: <1360932310-30065-1-git-send-email-lee.jones@linaro.org>
From: Rajkumar Kasirajan <rajkumar.kasirajan@stericsson.com>
End of charging is managed by SW.
Signed-off-by: Rajkumar Kasirajan <rajkumar.kasirajan@stericsson.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Reviewed-by: Jonas ABERG <jonas.aberg@stericsson.com>
Tested-by: Jonas ABERG <jonas.aberg@stericsson.com>
---
drivers/power/pm2301_charger.c | 48 +++++++++++++++++++++++++++++++++++-----
1 file changed, 43 insertions(+), 5 deletions(-)
diff --git a/drivers/power/pm2301_charger.c b/drivers/power/pm2301_charger.c
index ed48d75..62a172e 100644
--- a/drivers/power/pm2301_charger.c
+++ b/drivers/power/pm2301_charger.c
@@ -192,11 +192,22 @@ static int pm2xxx_charging_disable_mngt(struct pm2xxx_charger *pm2)
{
int ret;
+ /* Disable SW EOC ctrl */
+ ret = pm2xxx_reg_write(pm2, PM2XXX_SW_CTRL_REG, PM2XXX_SWCTRL_HW);
+ if (ret < 0) {
+ dev_err(pm2->dev, "%s pm2xxx write failed\n", __func__);
+ return ret;
+ }
+
/* Disable charging */
ret = pm2xxx_reg_write(pm2, PM2XXX_BATT_CTRL_REG2,
(PM2XXX_CH_AUTO_RESUME_DIS | PM2XXX_CHARGER_DIS));
+ if (ret < 0) {
+ dev_err(pm2->dev, "%s pm2xxx write failed\n", __func__);
+ return ret;
+ }
- return ret;
+ return 0;
}
static int pm2xxx_charger_batt_therm_mngt(struct pm2xxx_charger *pm2, int val)
@@ -245,13 +256,29 @@ static int pm2xxx_charger_wd_exp_mngt(struct pm2xxx_charger *pm2, int val)
static int pm2xxx_charger_vbat_lsig_mngt(struct pm2xxx_charger *pm2, int val)
{
+ int ret;
+
switch (val) {
case PM2XXX_INT1_ITVBATLOWR:
dev_dbg(pm2->dev, "VBAT grows above VBAT_LOW level\n");
+ /* Enable SW EOC ctrl */
+ ret = pm2xxx_reg_write(pm2, PM2XXX_SW_CTRL_REG,
+ PM2XXX_SWCTRL_SW);
+ if (ret < 0) {
+ dev_err(pm2->dev, "%s pm2xxx write failed\n", __func__);
+ return ret;
+ }
break;
case PM2XXX_INT1_ITVBATLOWF:
dev_dbg(pm2->dev, "VBAT drops below VBAT_LOW level\n");
+ /* Disable SW EOC ctrl */
+ ret = pm2xxx_reg_write(pm2, PM2XXX_SW_CTRL_REG,
+ PM2XXX_SWCTRL_HW);
+ if (ret < 0) {
+ dev_err(pm2->dev, "%s pm2xxx write failed\n", __func__);
+ return ret;
+ }
break;
default:
@@ -322,16 +349,27 @@ static int pm2_int_reg0(void *pm2_data, int val)
struct pm2xxx_charger *pm2 = pm2_data;
int ret = 0;
- if (val & (PM2XXX_INT1_ITVBATLOWR | PM2XXX_INT1_ITVBATLOWF)) {
- ret = pm2xxx_charger_vbat_lsig_mngt(pm2, val &
- (PM2XXX_INT1_ITVBATLOWR | PM2XXX_INT1_ITVBATLOWF));
+ if (val & PM2XXX_INT1_ITVBATLOWR) {
+ ret = pm2xxx_charger_vbat_lsig_mngt(pm2,
+ PM2XXX_INT1_ITVBATLOWR);
+ if (ret < 0)
+ goto out;
+ }
+
+ if (val & PM2XXX_INT1_ITVBATLOWF) {
+ ret = pm2xxx_charger_vbat_lsig_mngt(pm2,
+ PM2XXX_INT1_ITVBATLOWF);
+ if (ret < 0)
+ goto out;
}
if (val & PM2XXX_INT1_ITVBATDISCONNECT) {
ret = pm2xxx_charger_bat_disc_mngt(pm2,
PM2XXX_INT1_ITVBATDISCONNECT);
+ if (ret < 0)
+ goto out;
}
-
+out:
return ret;
}
--
1.7.10.4
next prev parent reply other threads:[~2013-02-15 12:44 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-02-15 12:44 [PATCH 00/40] Power: AB8500: Internal development push Lee Jones
2013-02-15 12:44 ` [PATCH 01/40] mfd: Differentiate between newly added abx500 based platforms Lee Jones
2013-02-15 12:44 ` Lee Jones [this message]
2013-02-15 12:44 ` [PATCH 03/40] abx500-chargalg: Store the AB8500 MFD parent device for platform differentiation Lee Jones
2013-02-15 12:44 ` [PATCH 04/40] ab8500-fg: Add power cut feature for ab8505 and ab8540 Lee Jones
2013-02-15 12:44 ` [PATCH 05/40] ab8500-fg: Report unscaled capacity Lee Jones
2013-02-15 12:44 ` [PATCH 06/40] ab8500-charger: Add backup battery charge voltages on the ab8540 Lee Jones
2013-02-15 12:44 ` [PATCH 07/40] ab8500-charger: Trivial coding style changes Lee Jones
2013-02-15 12:44 ` [PATCH 08/40] ab8500-bm: Quick re-attach charging behaviour Lee Jones
2013-02-15 12:44 ` [PATCH 09/40] pm2301-charger: Support for over voltage protection on the ab9540 Lee Jones
2013-02-15 12:44 ` [PATCH 10/40] ab8500-bm: Charge only mode fixes for " Lee Jones
2013-02-15 12:44 ` [PATCH 11/40] pm2301-charger: Force main charger detect Lee Jones
2013-02-15 12:44 ` [PATCH 12/40] pm2301-charger: Resolve I2C detection problem on ab9540 Lee Jones
2013-02-15 12:44 ` [PATCH 13/40] ab8500_charger: Prevent auto drop of VBUS Lee Jones
2013-02-15 12:44 ` [PATCH 14/40] pm2301-charger: Die temp thermal protection Lee Jones
2013-02-15 12:44 ` [PATCH 15/40] pm2301-charger: Wake system when ext charger is plugged-in Lee Jones
2013-02-15 12:44 ` [PATCH 16/40] ab8500-btemp: Filter btemp readings Lee Jones
2013-02-15 12:44 ` [PATCH 17/40] ab8500-fg: Allow capacity to raise from 1% when charging Lee Jones
2013-02-15 12:44 ` [PATCH 18/40] ab8500-charger: Add AB8505_USB_LINK_STATUS Lee Jones
2013-02-15 12:44 ` [PATCH 19/40] pm2301-charger: Always compile the PM2301 Charger driver with AB8500 Battery Mgnt Lee Jones
2013-02-15 12:44 ` [PATCH 20/40] ab8500-bm: Add usb power path support Lee Jones
2013-02-15 12:44 ` [PATCH 21/40] ab8500-btemp: Defer btemp filtering while initialising Lee Jones
2013-02-15 12:44 ` [PATCH 22/40] ab8500-bm: Add support for the new ab8540 platform Lee Jones
2013-02-15 12:44 ` [PATCH 23/40] ab8500-charger: Use USBLink1Status Register Lee Jones
2013-02-15 12:44 ` [PATCH 24/40] abx500-chargalg: Prevent the watchdog from being kicked twice Lee Jones
2013-02-15 12:44 ` [PATCH 25/40] ab8500-chargalg: Use hrtimer Lee Jones
2013-02-15 12:44 ` [PATCH 26/40] ab8500-charger: Add UsbLineCtrl2 reference Lee Jones
2013-02-15 12:44 ` [PATCH 27/40] pm2301-charger: Adjust interrupt handler behavior Lee Jones
2013-02-15 12:44 ` [PATCH 28/40] pm2301-charger: Add pm_runtime_resume & pm_runtime_suspend Lee Jones
2013-02-15 12:44 ` [PATCH 29/40] ab8500-charger: Run detect workaround only on AB8500 Lee Jones
2013-02-15 12:45 ` [PATCH 30/40] pm2301-charger: Removed unused code from PM2301 driver Lee Jones
2013-02-15 12:45 ` [PATCH 31/40] abx500-chargalg: Use module_platform_driver() rather Lee Jones
2013-02-15 12:45 ` [PATCH 32/40] ab8500-charger: Remove duplicate code Lee Jones
2013-02-15 12:45 ` [PATCH 33/40] pm2301-charger: lpn pin used only in C2C boards Lee Jones
2013-02-15 12:45 ` [PATCH 34/40] pm2301-charger: Charging LED control for pm2301 Lee Jones
2013-02-15 12:45 ` [PATCH 35/40] ab8500-bm: Trivially fix up some incorrect and out-of-date comments Lee Jones
2013-02-15 12:45 ` [PATCH 36/40] pm2301-charger: Wake device on register access Lee Jones
2013-02-15 12:45 ` [PATCH 37/40] pm2301-charger: Reference put missing after access Lee Jones
2013-02-15 12:45 ` [PATCH 38/40] abx500-chargalg: Add charging current step interface Lee Jones
2013-02-15 12:45 ` [PATCH 39/40] ab8500-fg: Change current calculation Lee Jones
2013-02-15 12:45 ` [PATCH 40/40] ab8500-charger: Do not use [delayed_]work_pending() Lee Jones
2013-03-02 23:33 ` [PATCH 00/40] Power: AB8500: Internal development push Anton Vorontsov
2013-03-04 10:08 ` Samuel Ortiz
2013-03-04 17:49 ` Anton Vorontsov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1360932310-30065-3-git-send-email-lee.jones@linaro.org \
--to=lee.jones@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).