[PATCHv2 3/7] pinctrl: gpio: vt8500: Add pincontrol driver for arch-vt8500

[linux@prisktech.co.nz (Tony Prisk)]

On Mon, 2013-03-25 at 11:05 -0600, Stephen Warren wrote:
> On 03/22/2013 11:13 PM, Tony Prisk wrote:
> > This patch adds support for the GPIO/pinmux controller found on the VIA
> > VT8500 and Wondermedia WM8xxx-series SoCs.
> > 
> > Each pin within the controller is capable of operating as a GPIO or as
> > an alternate function. The pins are numbered according to their control
> > bank/bit so that if new pins are added, the existing numbering is maintained.
> > 
> > All currently supported SoCs are included: VT8500, WM8505, WM8650, WM8750 and
> > WM8850.
> 
> > diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-vt8500.txt
> 
> > +Required properties:
> 
> > +- gpio-controller: Marks the device node as a GPIO controller.
> > +- #gpio-cells : Should be two. The first cell is the pin number and the
> > +  second cell is used to specify optional parameters.
> 
> What are those optional parameters? This binding should define them.
There are actually no optional parameters at the moment - but there will
be at some point. In our original GPIO driver binding it was suggested
that a flags cell be added. When moving it to the pinctrl driver
binding, the bank + pin number cells were combined as we have linear
numbering now, and the flags property was retained.

- #gpio-cells : should be <3>.
	1) bank
	2) pin number
	3) flags - should be 0

I will clarify this in the next version.
> 
> > +Optional properties:
> > +- wm,pinmux: A value and mask pair describing the configuration changes to
> > +  the pinmux register. Only bits marked 1 in the mask will be changed.
> 
> This needs more explanation. What does this do and why is it needed?

This is the bit that is causing most of the trouble with this patchset.

This binding exposes a 32-bit register which is basically a mux
register, but a messy one at that.

The bit values seem to change on each of the different SoCs, we have no
hardware docs for most of the later SoCs so it's very much guess-work.
Because we don't have the doc's, we don't know which pins are
function-swapped when changing bits in this register so writing a proper
pinmux driver is impossible.

We currently only use this register to ensure the DVO/LCD output is
enabled for the framebuffer driver. On the vt8500 SoC, this is bit 0 -
all later SoCs use bit 31.

I exposed it this was so that we don't need to change anything in the
future as new functions are found. The DTS can be modified to
enable/disable the functions directly. It would make even more sense
once we get a C header or similar with #define's to describe what each
bit does.

Given the confusion/hesitation around this one property, I am tempted to
drop it from the patchset and leave the original code in
arch/arm/vt8500.c to enable the LCD output.


> Other than that, this binding looks fine.

Regards

Tony Prisk